130w Co2 Laser Power Supply For Engraver Engraving Cutting Cutter Pxtn

US $5460

  • Shanghai, China
  • Jan 30th
130W CO2 LASER POWER SUPPLY FOR ENGRAVER ENGRAVING CUTTING CUTTER GENERATOR CONTROLLER ELECTRONIC GTR168 1PC CONTROL MODULE BRAND NEW GTR-168 INDUSTRIAL WATER CHILLER FOR CNC/ LASER ENGRAVER ENGRAVING MACHINES CW-5200 NEW ARRAY 3710A USB PROGRAMMABLE DC ELECTRONIC LOAD 150W 0~360VDC 0~30ADC 96 LED FOR OLYMPUS SZ51/SZ61/SZX7/SZX9/SZ12/SZX16/SZX10 MICROSCOPE ILLUMINATOR Features: 1. High response speed, Dramatically lengthen the life of laser. 2. Easy control: The start and stop of laser can be easily controlled by TTL level. And there are protection switch to test the external water, ventilation, etc. 3. Easy control of laser power: Both 0 - 5V analog signal and PWM signal can control the laser power. 4. The power supply has open circuit protection: Under the condition of good protective earthing, the power supply can work in open-circuit for a short time, which could avoid the damage of laser power supply because of the bursting of laser tube, thereby enhancing the life of power supply. 5. The power supply can take feedback interface which can be used in closed-loop control and testing the working current of laser. 6. Application: Acrylic sculpture, cut; fabric sculpture, cut; rubber sheet sculpture, cut; etc. Technical parameters: AC Input Voltage AC 220V AC frequency 50HZ Maximum Input Power 550 w Maximum Input current 5A Maximum Output voltage DC 40 KV Maximum Output current 28 mA ( up to the laser tube) Efficiency 91% Average fault free time >=10000h Response time

Directions

Similar products from Laser Modules

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies