3/8-24unf-2a Magnetic Rotate Speed Sensor Pick Up Sender Ring Gear Teeth Msp6729

US $18.44

Houston, Texas, United States
Aug 27th

Open on mobile:
QR code

We offer a 60-day no-questions-asked money-back return policy starting on the day the buyer placed the order. For buyers' cause, buyers pay return shipping costs, and the buyer will receive a refund for the product cost only. For sellers' cause, buyers pay return shipping costs in advance, and the buyer will receive a full refund and the shipping cost to ship back. It is essential to order the correct parts to avoid delays and returns. It is important not to connect either of the speed sensor leads to anything but the speed control unit used. The shield should not be connected at the speed sensor end. Please note that due to the size of our products, occasionally we are unable to ship to PO Boxes. Make sure to provide us with the correct, precise, and detailed shipping address to avoid any delivery issues. Please note that import duties, taxes, and charges are not included in the item price or shipping charges. These charges are the buyer's responsibility. Please check with your country's customs office to determine what these additional costs will be prior to bidding/buying. The device has a 3/8-24 UNF threaded design with a length of 2.5 inches and comes equipped with a 6-foot shielded cable. All our Magnetic Speed Sensors are designed and tested to operate within a temperature range of -65°F to 225°F (-55°C to 105°C). The wire leads should be twisted for their entire length from the magnetic speed sensor to the control unit, and they may need shielding if they are longer than 10 ft or if external interference is present. The MSP6729 Magnetic Rotate Speed Sensor is a high-quality device designed to measure the speed of your engine. It is compatible with any ferrous gear and provides accurate signal frequency and amplitude. The sensor should be mounted in the ring gear case or flywheel bell housing of the engine, with the threaded hole perpendicular to the centerline of the crankshaft and centered over the ring gear teeth. A spot face should be present to provide a flat surface on which to anchor the locknut.

Condition:	New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...	Brand	Unbranded
UPC	632296666297
MPN	MSP6729