60 HP 1800 RPM Crusher Duty Motor PE364T-60-4C, US $2,300.00 – Picture 0

60 HP 1800 RPM Crusher Duty Motor PE364T-60-4C, US $2,300.00 – Picture 1

60 HP 1800 RPM Crusher Duty Motor PE364T-60-4C, US $2,300.00 – Picture 2

60 HP 1800 RPM Crusher Duty Motor PE364T-60-4C, US $2,300.00 – Picture 3

60 HP 1800 RPM Crusher Duty Motor PE364T-60-4C, US $2,300.00 – Picture 4

60 Hp 1800 Rpm Crusher Duty Motor Pe364t-60-4c

US $2,300.00

Casper, Wyoming, United States
Feb 20th

Open on mobile:
QR code

60 HP 1800 RPM Crusher Duty Motor PE364T-60-4C North American Electric Catalog: PE364T-60-4C For use on crushing and pulverizing equipment and other industrial equipment requiring extremely high starting torques and breakdown torques. Meets or exceeds EISA Efficiency Requirements 1.15 Service Factor Shipping Weight: 841 60 HP 1800 RPM 208-230/460 Volts Three Phase 364T Frame NEWT Frame Type Foot Mount Totally Enclosed Fan Cooled (TEFC) Enclosure IP55 Protection (Ingress Protection); Protected against tools and wires over 1mm, Protected against dust (limited ingress), Protected against low-pressure jets of water from all directions, limited ingress permitted. Inverter Rated (10:1 variable torque; 5:1 constant torque) NEMA Design C performance Class F insulation system, class B rise at full load 40° C ambient continuous duty Corrosion resistant epoxy paint Stainless steel nameplate and zinc plated hardware Dual voltage ratings suitable for part wind start on lower voltage Suitable for wye-delta start on 213T frame and above F1/F2 reversible Suitable for 575V @ 1.0 Service Factor C-Flange and D-Flange field conversion kits available Cast iron frame construction including the conduit box Feet are dual drilled on most frames for mounting flexibility Sealed bearings thru 215T frame Regreasable open bearings 254T frame and above Mechanical "V" Seal on drive end Vacuum Pressure Impregnation for all windings Condensation drains with plastic plugs Lifting provisions on 143T frame and above ISO (International Organization for Standardization) 9001 Certification CSA (Canadian Standards Association) Certification C + US Certification Class I, Div II Groups ABCD, T2B; Class 1 - Flammable gases or vapors are present in the air in quantities sufficient to produce explosive or ignitable mixtures. Div II - The substance referred to by class is present only in abnormal conditions, such as a container failure or system breakdown. Group A - Acetylene. Group B - Hydrogen, fuel and combustible process gases containing more than 30% hydrogen by volume or gases of equivalent hazard such as butadiene, ethylene, oxide, propylene oxide and acrolein. Group C - Carbon monoxide, ether, hydrogen sulfide, morpholine, cyclopropane, ether and ethylene or gases of equivalent hazard. Group D - Gasoline, acetone, ammonia, benzene, butane, cyclopropane, ethanol, hexane, methanol, methane, vinyl chloride, natural gas, naphtha, propane or gases of equivalent hazard. T2E - 500 Deg. F Max Surface Temp.

Condition:

New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...

Brand

North American Electric Motor