Aoyue 710 Infrared SMT Soldering / Unsoldering System, US $450 – Picture 0

Aoyue 710 Infrared SMT Soldering / Unsoldering System, US $450 – Picture 1

Aoyue 710 Infrared SMT Soldering / Unsoldering System, US $450 – Picture 2

Aoyue 710 Infrared SMT Soldering / Unsoldering System, US $450 – Picture 3

Aoyue 710 Infrared Smt Soldering / Unsoldering System

US $450

Laguna Niguel, California, United States
Feb 28th

Open on mobile:
QR code

This auction is for a very lightly used Aoyue 710 Focused Infrared Welding System. This is the preferred unit for soldering and unsoldering surface mount parts on printed circuit boards. Right now, I looked on eBay and found none of these professional units available for sale. Problems associated with Hot Air soldering and desoldering are eliminated. The Aoyue 710 can be used for reworking BGA, micro BGA, QFP, PLCC, SOIC small SMD and other circuit board components. In a Nutshell, the technique is to place the circuit on the PCBA supports above the infrared Pre-heater. Then holding the infraredsoldering gun, you finish the heating and either remove the part or finish the pad soldering to the PCBA. Included in this auction is: Main Station Preheating station Foot Switch Infrared Soldering Gun Welding Goggles Instruction Manual I do not have the Power Cord, but it is the standard style with three small blades that goes into computers, printers and monitors. Some people will think that using infrared welding goggles are a bit over the top, but they are a safety element that must be worn. Infrared energy cannot be seen by the human eye, but given enough of it, your eye could be damaged - and you will get a heck of a sunburn. There are two controls on the front of the main unit - and corresponding LED's that read out the temperature settings of both the preheat and soldering gun. The preheater can be set from 100 to 500 degrees Centigrate. The Solderlight Gun can be set from 100 to 450 degrees centigrate. It takes a bit of practice to do this well. If the preheater is set too high or your PCBA is left on too long, it can warp. So it takes some time to make it just right - sort of adjusting the tone, volume and balance of the car stereo in your car. Once you have the knack, you can really go into production. This device will help your manufacturing or repair operation make more money. The objective is to take the bad part off and get the new part on quickly - this is the device that will help you do just that. Buy and enjoy. Powered by eBay Turbo Lister The free listing tool. List your items fast and easy and manage your active items.

“Good condition - Purchased and it sat on the bench - almost never used.”

Brand	Aoyue
Country/Region of Manufacture	China
Model	710