As32 2r025 - High Energy Icl Thermistor Aqua-rite Glx-pcb-rite Hayward/goldline

US $13.59

Diamondhead, Mississippi, United States
Jan 29th

Open on mobile:
QR code

Ametherm AS32 2R025 High-Energy Thermistor For HAYWARD / GOLDLINE / AQUA-RITE GLX-PCB-RITE This board failure is often due to the "sacrificial" destruction of the thermistor used to protect the circuit from high voltage and high current surges that could occur after a lighting strike during thunderstorms or other power surge. Normally the thermistor protects the circuit on start-up, providing a relatively high resistance (2 Ohm) at ambient temperature to limit "InRush Current", and then essentially disappearing from the circuit (0.02 ohm) when the current is near or equal the design current of 25 Amp. The part will fail when a power surge is much greater than the power handling capability of the part. The correct replacement thermistor is: Ametherm ICL - AS32 2R025 Higher Energy Dissipation without Failure (Can dissipate twice the energy before failing than the SL version.) (Lower Voltage Systems can use SL32 2R025) Inrush Current Limiting (ICL) Thermistor (1 Thermistor) (Inrush Current Limiting Thermistors) (Use to repair: Hayward Aqua Rite PCB (GLX-PCB-RITE) Pool Chlorinator) Note: Either AS32 2R025 or SL32 2R025 may be used if power is 240 V (AC) or less, but the AS Thermistor will protect against a higher energy surge. ICLs (Inrush Current Limiters) are a cost-effective way of limiting the inrush of current that can damage other components in a switching power supply and other devices when the equipment is turned on. -- AMETHERM AS32 2R025 -- (Straight Leads) PLEASE NOTE SL32 2r025 is for Circuit Voltages Up to 240 VAC AS32 2R025 is for Circuit Voltages up to 680 VAC (And all voltages for protection against a greater energy surge.) DataSheet Available at: http://www.ametherm.com/Data%20Sheets/AS32%202R025.pdf Resistance at 25 °C -- 2 Ohms Max. Steady State Current -- 25 Amperes Resistance @ Max. Steady State Current -- 0.024 Ohms "D" Max. Coated Diameter -- 30 mm "T" Max. Coated Thickness -- 6.35 mm Lead Diameter -- 0.8 mm PC Board mountable. Lead Length: 38 mm (1.5 inches) High Current ICL Thermistors. These are great for those projects or prototypes where a high current (25A) limiting thermistor is required. "Buy It Now" ************************************************** Be sure to add us to your favorites list! *************************************** Check out our other Thermistor values! *************************************** Visit our eBay store for thermistors and other electronic component values! STI Online Trading Center: http://stores.ebay.com/STI-Online-Trading-Center ***************************************

Condition:	New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...	Brand	Ametherm
MPN	Ametherm AS32 2R025
Model	AS32 2R025
Country/Region of Manufacture	United States