Atmega328p Board W/ Nrf24l01+ Breakout Port In Arduino Pro Format +dht22 Port

US $9.90

  • Ljubljana, Slovenia
  • Jan 29th
ATMega328p board with NRF24l01+ breakout port in Arduino PRO format +I2C port +DHT22port +1.25A Mosfet Fully Arduino compatible with Arduino PRO Mini 3.3V @ 8MHz bootlader Some goodies: NRF24l01+ radio breakout port with CE and CSN pins connected to digital pins 7 and 8 ( you use RF24 radio(7, 8); in Arduino code). There is a 1uF capacitor connected across Vin and GND of the port bigger LDO voltage regulator to supply the board with enough power for additional circuits two breakout ports with SDA, SCL lines and 10k pull-up resistors for external I2C components DHT11/22 port with 4.7k pull-up resistor additional port with power supply and GND connections 1.25amp 30V n-channel MOSFET for regulating external components such as solenoids. The output is protected with Schottky diode. low power (2mA) LED diodes that are connected via solder jumper. Jumper needs to be soldered. There are few such boards available and none with this kind of versatility. What makes it special? This board is perfect for low-power applications. Identical - small - footprint as Arduino PRO. Only better. It is intended for sensor applications and can be used as an universal board for sensor node networks. Dimensions are 2 inch x 2.1 inch. The board is 1mm narrower than Arduino PRO, to fit into 2inch slot of an enclosure.

Directions

Similar products from PCB boards & Kits

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies