Centrifuge 8 Place Fixed Speed Perfect For Blood Separation Valentine Sale Price

US $285.00

Fort Lauderdale, Florida, United States
Jan 30th

Open on mobile:
QR code

FIXED SPEED CENTRIFUGE FOR BLOOD SEPARATION! THIS PRODUCT IS MANUFACTURED IN THE USA With proper care and maintenance, the E-8 centrifuge will provide years of laboratory service. Please follow the following recommended guidelines: Use only quality test tubes which are rated for 1350 g-force or greater. Never force a tube into the tube shield. The tube shields were designed to hold the most common sized tubes, Vaccutainers, and SST’s. Some plastic, conical, and glass test tubes are too large and should not be used in the E-8. Keep the tube shields clean. If a tube does break, either dispose of the entire tube shield (and remove the opposite shield—for proper balance) or safely dispose of the sample and broken glass and thoroughly clean and disinfect the inside and outside of the tube shield. Additional tube shields are available for purchase from LW Scientific, Inc. Motor and electrical maintenance: The E8 utilizes a brushless induction-type motor and its bearings are permanently lubricated.* It should not need servicing for the life of the centrifuge. Likewise, the electrical components were designed for high reliability and should not need regular service. However, if repairs should be needed, please contacT seller. Care and Maintenance Nominal speed: 3,300 RPM (+/-5%) Nominal RCF : 1,350 g Max. Volume : 120 ml Max. Power: 110 volt or 220 volt voltage and amperage are variable to 240 volts 50 cycle Height: 10 inches Width: 10 inches Weight: 11 lbs. Boxed dimension s: 13 x 13 x 12inches Boxed Weigh t: 12 lbs. Fluid Recommendations: Specifications RCF (g’s) 1,350 Radius (mm) 112 RPM’s 3,300 Whole Blood 3300 10 min. Speed Time Average Speeds for Variable Unit (E8V) Dial Setting: Low (6:00 position) 900-1200 Medium (9:00 position) 1500-1900 Medium (12:00 position) 2400-2800 High(3:00 position) 3200-3350 Because of the safety issues with high g-forces in a centrifuge, it is recommended that rotors, buckets, and tube sleeves be inspected every 6 months for corrosion and fatigue. If there is any indication of wear, the rotor, buckets, and sleeves should be removed from service. Following these procedures will ensure safety of lab personnel as well as extend the life of the centrifuge. RPM Range:

Condition:

New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...

Model

E8C-08AF-1501