DIY kit LED electronic clock microcontroller LED digital clock time thermometer, US $19.78 – Picture 0

DIY kit LED electronic clock microcontroller LED digital clock time thermometer, US $19.78 – Picture 1

DIY kit LED electronic clock microcontroller LED digital clock time thermometer, US $19.78 – Picture 2

DIY kit LED electronic clock microcontroller LED digital clock time thermometer, US $19.78 – Picture 3

DIY kit LED electronic clock microcontroller LED digital clock time thermometer, US $19.78 – Picture 4

DIY kit LED electronic clock microcontroller LED digital clock time thermometer, US $19.78 – Picture 5

DIY kit LED electronic clock microcontroller LED digital clock time thermometer, US $19.78 – Picture 6

Diy Kit Led Electronic Clock Microcontroller Led Digital Clock Time Thermometer

US $19.78

HongKong, China
Jun 9th

Open on mobile:

Diy Kits Descriptions: 1. T12 digital temperature controller (vibration switch + LED + knob) 2. T12 Soldering Tip shape-k Input voltage: 12V-24V Temperature adjustment range: 200C-480C Maximum Power: 70W 3. T2 / T12 handle (907 handle conversion) Applies to T2 / T12 Series Tip, default is black color. 4. T2 / T12 inner tube bracket kits 5. 951/936 / T12 iron handle silicone 5 Core cable Outer diameter: 5mm, suitable 9501/2028/912 ,cable length: 100cm 6. Soldering station iron 5 core aviation plug 7. Other cable/accessories (as picture shows) Installed Note: 1. Strictly reference shop tutorials, well insulated and grounded against static electricity. 2. Before power test, carefully check the wiring is correct, whether Weld and short, full power test machine after confirmation. 3. connect 12-20V DC, if received more than 20V power supply, to be put on the back of 1,206,100 ohm board (labeled 101) resistor removed. please you see below picture. 4. When you configure the power supply voltage and current requirements themselves refer to the following table: Power (third column) is determined by the voltage (first column), as long as the current reaches the minimum current (second column). Measuring Machine normal, lights and display status: 1. Unplugged T12 tip, turn the light flashed off, show SER, 1 seconds after the display 500. 2. T12 plug tip, boot light uniform flashing, indicating rapid heating from room temperature generally show the set temperature to rise, approaching the set temperature, strobe lights. Indicator is not flashing or intermittent flashes, indicating that the tip temperature reaches the set temperature or alternating temperature compensation. When measuring machines on display digital bounce questions: Because with the new T12 tip, the tip inside the heater did not burnt, it will be just a little jump start with warm, generally do not need special treatment, the natural use of 1-2 days basically not bounce up. If you need effective immediately, the general recommendations of the temperature to 350-380 while heating to the point of tin iron head, burning off after 4-5 minutes, until the tip to cool before you can reboot! (1 no action can be repeated 2-3 times) Package Contents 100% Brand New 1x As the main picture shows

Condition:	New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...	Brand	Unbranded/Generic
Country/Region of Manufacture	China
MPN	Does Not Apply
UPC	Does not apply