Dow Filmtec BW30-400/34i LE-400 WET Reverse Osmosis Membrane Element 40.5" x 8", US $499.99 – Picture 0

Dow Filmtec BW30-400/34i LE-400 WET Reverse Osmosis Membrane Element 40.5" x 8", US $499.99 – Picture 1

Dow Filmtec Bw30-400/34i Le-400 Wet Reverse Osmosis Membrane Element 40.5" X 8"

US $499.99

Lee's Summit, Missouri, United States
Jan 30th

Open on mobile:
QR code

Dow Filmtec LE-400 Reverse Osmosis (RO) Membrane 11,5000 GPD industrial / commercial low energy replacement reverse osmosis (RO) membrane element The Filmtec LE-400 element is a low-energy element for industrial and municipal applications that operates at low pressure to deliver energy savings in new equipment or replacement situations where energy cost is an important factor and unit price is a key driver. Delivers equivalent permeate flow at 40% lower feed pressure, compared to the Filmtec BW30-400. Offers the proven performance and high productivity of the Filmtec BW30-400 element construction, with lower energy use and operating expense. The new Filmtec LE-400 has an industry standard 1.125 inch ID permeate tube to facilitate element replacement. Specifications: Membrane Type: Polyamide Thin-Film Composite (TFC) Maximum Operating Temperature: 113F (45C) Maximum Operating Pressure: 600 psi (41 bar) Maximum Pressure Drop: 15 psi (1.0 bar) Maximum Feed Flow Rate: 85 gpm (19 m3/hr) pH Range, Continuous Operation: 2-11*** pH Range, Short-Term Cleaning: 1-13* (30min) Maximum Feed Silt Density Index: 5 SDI Free Chlorine Tolerance: <0.1 ppm** Permeate Flow Rate: 11,500 GPD (44 m3/day)* Stabilized Salt Rejection: 99.3% *Permeate flow and salt rejection based on the following standard conditions: 2,000 ppm NaCl, 150 psi (10.3 bar), 77°F (25°C), pH 8 and 15% recovery. For comparison, the LE-400 will have a permeate flow of 12,200 gpd (46 m3/d) and stabilized salt rejection of 99.3% when normalized to a feed solution of 1,500 ppm NaCl as used by some manufacturers. Flow rates for individual elements may vary but will be no more than 15% below the value shown. **Under certain conditions, the presence of free chlorine and other oxidizing agents will cause premature membrane failure. Since oxidation damage is not covered under warranty, Dow recommends removing residual free chlorine by pretreatment prior to membrane exposure. Most RO systems have carbon pre-filters for this purpose. ***Maximum temperature for continuous operation above pH 10 is 95F (35C). Note: Active surface area guaranteed +/-3%. Active area as stated by Filmtec is not comparable to nominal membrane area often stated by some manufacturers.

Condition:	New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...	Brand	Filmtec
SAVE OVER 400.00 EACH	RETAILS 947.95
Model	le-400 WET
GMID 249109	249109
MPN	BW30-400/34i
BW30-400	DISCOUNTS ON QUANITY ORDERS
General Condition	New in the Box