E-ink E-paper Display Module 3.3v 2.04 Inch 177x72

US $25.90

  • Shenzhen, China
  • Jun 9th
Description: This E-ink display module is special made for E-ink display development, no need to build any additional circuit and component, you can run this E-ink display module directly with your project. Features: Ultra low power consumption Super wide viewing angle - near 180° Extra thin & light High Resolution SPI interface Four gray shade colors All necessary component included Integrating boosted circuit Specifications: Resolution: 172x72 Display thickness: 1.18mm Display Dimension: 2.04inch, Module dimension: 30.13x60.26mm Pixel Pitch (mm): 0.28(H) X 0.28(V) / 95dpi Contrast Ratio: 10:1 Display Color: 4 gray shade colors, White, Gray, Deep gray, Black Refresh Time (room temp.): 1 sec Interface: SPI Operation Temperature: 0~50°C Storage Temperature: -20~60°C Module Weight: 15g Port:          SPI: CS, SCLK, MOSI(SDA)          D/C: Data/command control          BS1: BUS interface selection pin          Bu: Busy state output pin          RES: Reset signal input          VCC: 3.3V          GND: Ground  Technical Support: Provide demo code based on STM32, smoothly transfer to other MCU, including 3.3V Arduino. If you need further help, please email to support@smart-prototyping.com.
Condition:
New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...
Brand Noa Labs
Model 101284

Directions

Similar products from Circuit Breakers & Surge Protectors

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies