New in Box Emergi-Lite RSM27-2 Recessed Light - 6v 27w Constructed of steel cabinet with a corrosion resistant coating and plastic for long lasting durability. Features • Each unit comes with two (2) 6V 9W high-intensity incandescent EF-9 lamp heads (standard). • Constructed of 20-gauge steel with an off-white baked enamel finish • Available with sealed, maintenance-free Lead-Calcium battery • PulsePlus Charger circuitry offers 120/277V input 60 Hz., 0.3/0.15A (other inputs available), fused output circuit(s), dual diagnostic indicator lights, temperature compensated charger, sealed relay, low voltage battery disconnect, brownout protection and lock out (automatic battery connect) • Fully-recessed assembly for ceiling or wall mount. Includes adjustable bar hangers for grid ceilings. Can be framed into studs/ joists • UL924 Listed. Complies with NEC, Life Safety Code and OSHA Approved use in the Commonwealth of Pennsylvania and New York City Electrical Power Requirements: 120/277 Vac, 60 Hz., 0.3/0.15 Amp Output: 6 volt fused outputcircuit. Transfer: dust-tight relay automatically and instantly energizes lamp load upon failure of AC supply. LVD: low voltage battery disconnect circuit automatically disconnects the lamp load and circuitry when battery reaches 871/2% discharge to protect the battery from deep discharge and permanent damage. Lockout: labor saving electronic circuit automatically connects battery when the AC circuit is activated. Brownout: close tolerance electronic circuit activates emergency unit when utility power dips below 80-85% of nominal voltage. Charger: The pulse plus charging circuit utilizes an integrated circuit chip which samples the battery in relation to its temperature, state of charge and input voltage fluctuations. The charger is current limited, temperature compensated, shortcircuit proof and reverse polarity protected. Charger regulation ±1%. The equipment is capable of full recharge in compliance with Underwriters 924 specification. Transformer: 120/277 volt. Controls: test switch and dual diagnostic LED indicator lights, Hi-charge and AC pilot. Suggested Specification Supply and install Emergi-Lite® Series RSM in 6V, with electrically compatible remote fixtures or exit signs as indicated on the plans. The emergency lighting unit shall be an architecturally designed, self-contained fixture including sealed, maintenance-free battery: TYPE RSM to be supplied with Lead-Calcium battery. The unit charger shall utilize an integrated circuit which samples the battery in relation to its temperature, state of charge and input voltage fluctuations. The charger shall be current limited, temperature compensated, short-circuit protected and reverse polarity protected. The unit shall be furnished with an electronic lockout circuit which will connect the battery when the AC circuit is activated, and an electronic brownout circuit which will activate the unit when utility power dips below 80-85% of nominal voltage. A low voltage battery protection circuit shall be provided and will disconnect the load and circuitry from the fused output circuit when battery reaches 871/2% of its nominal voltage. The unit shall be capable of full recharge in compliance with UL924 specifications. The unit shall be furnished with a sealed, dusttight relay, a test switch and dual diagnostic LED indicator lights (Hi-charge and AC pilot). The unit shall be designed for fully recessed installation in walls or ceilings, including grid type suspended ceilings. Unit shall be constructed of 20 gauge steel with a off-white baked enamel mounting plate. Unit will be furnished with two (2) lampheads as follows: TYPE EF-9 decorator heads; 6V, 9W lamp per head. Fused output terminals shall be provided for ease of remote lamp connections. The unit shall be Emergi-Lite® model: . Diagnostic/Self Test Feature (Optional) Advanced Diagnostics (audible and non audible versions) Our Advanced Diagnostic circuitry is designed to continuously monitor every critical function of the unit, attached remote lighting heads and exit signs. Operational status is indicated by colored LED lamps. A high-pitch audible alarm and an LED status indicator alert maintenance personnel to a unit malfunction. This option saves the time spent on testing and trouble shooting by maintenance personnel. This new generation of Emergi-Lite diagnostics is perfect for any application. The self test will test the unit for a minimum 30 seconds every 30 days, 30 minutes every six months and 90 minutes annually. Self-testing in accordance with NFPA 101, Life Safety Code. Unit tests itself every thirty days for one minute, thirty minutes on the sixth month and ninety minutes annually. Thank you for shopping here! Fast Shipping Packages are usually shipped by 6pm (central time) the same day or one business day after purchase. Most shipments are via the US Post Office. For large or heavy items, Fed Ex Standard shipping might be used, at the seller's discretion. Shipping Address Please make sure all address information is correct before making your purchase. Address changes are not possible after the purchase is made. eBay email / Feedback Customer satisfaction is our priority. After receiving your item, please contact seller by eBay email with any questions or concerns. Customer feedback is appreciated. Thank you for your purchase! ** Please note: Shipping to a PO Box, a US territory, Hawaii, or Alaska may require an additional shipping charge. Contact seller for shipping cost before purchase.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.
