Fluke Dsp-4000 Cable Tester Complete Set Free Shipping 49 States

US $765

Bothell, Washington, United States
Feb 28th

Open on mobile:
QR code

Here is a complete Fluke DSP-4000 cable tester setup in good used condition except for a serious issue, please read everything. One day the remote unit would no longer start up at all. After consulting with a Fluke tech he said the guts are the same between the two units (except for the firmware) and you can swap boards to make a diagnosis. By this method I found the remote's digital board was bad. Through an incredible amount of effort I obtained a brand-new digital board and installed it, now both units power up successfully and the main unit sees the remote unit through the cal module. Both units have the latest firmware loaded. The remaining problem is that when you connect the units with the cal module and run the self-test it doesn't complete. It said "Digital Pass" and soon after that the remote unit started beeping and its LEDs started flashing and then communication between the units was lost until power was cycled. I moved the new digital board to the main unit and repeated the self test, now it just reports "internal error 108" which my Fluke contact said is an internal calibration error due to the digital board being replaced. The new digital board is now back in the remote. Fluke no longer accepts these testers for repair or calibration and I guess I am just done fooling with this. I will include the original digital board, maybe you can resurrect it? It has no visible damage. All of the circuit boards appear normal, nothing cracked, missing, etc. and no corrosion anywhere. Maybe you have more experience with these or more capability than I have? I hope so and I wish you good luck. At this point the main unit seems to be functioning normally for things not requiring the remote to be connected on the other end. It can measure cable length, all monitor functions, impedance, TDX, TDR, generate a tone and all coaxial tests, see chart. The remote in its present state does work for wire mapping. The photos show everything that is included with this. Everything listed in the manual as standard equipment is there and everything is in good physical condition except as noted: DSP-4000 Main unit (previous owner name etched, short scratch on lens) DSP-4000 Smart Remote unit (previous owner name etched at bottom of face) 2 DSP-LIA011 Basic Link Adapters for Cat 5 (missing lock tabs) DSP-LIA012 Channel Adapter for Cat 5 DSP-LIA013 Channel/Traffic Adapter for Cat 5 2 DSP-LIA021 Basic Link Adapters for Lucent Gigaspeed 2 original AC adapters/chargers 2 brand-new aftermarket NiMH battery packs 1 headset (1 missing) DSP-4000 CAL calibration module 2-meter RJ45 patch cord 50-ohm BNC coax cable RJ45 to BNC adapter Serial interface cable plus adapter (not shown) for connecting to LinkWare 6.2 Manual Carrying case (a little dirty but good condition overall) I always try to be an honest seller and I have described everything the best I can. Please ask any questions before bidding if I have missed something. I promise nothing beyond what I can see to describe. I think this could be a great bargain for the right person but it is definitely AS-IS at this moment. Buy today from a reliable seller on eBay for over 14 years and get fast, free shipping to 49 states only. Thanks for looking. ------------------------------------ ------------------------------------ Trust my perfect feedback, Buy with confidence! Note: I officially don't accept returns for nuisance reasons such as changed your mind, didn't understand what you were buying, etc. If, however, there is a significant mistake in the listing or there is a defect not stated in the listing then I will do whatever is needed to make it right just as I have done for years. I didn't get to this level of perfect feedback by accident. Powered by eBay Turbo Lister The free listing tool. List your items fast and easy and manage your active items.

“needs calibration or other repair, read description”

Brand	Fluke Networks
Model	DSP-4000