Heli - Flow Oil Mist Collector

US $5,000.00

Cedar Rapids, Iowa, United States
Jan 30th

Open on mobile:
QR code

Correct photos coming soon, having problems downloadingHelical dynamics heli flow system Model M 5000 Design flow 5000 cfm Electrical data Horsepower 10 12 amps 230/460 volt 3 phase currently wired 460 All stainless steel construction Shipping weight is 1600 pounds Lower unit measures 34 inches wide by 72 inches long by fifty five and one half inches high upper and lower box rails measure 38 inches wide Upper unit is 34 inches wide by 47 inches long by 16 and one half inches high including the lid The upper side intake openings are three and one quarter inches the lid unit is one and one half inches high overall height is 72 inches The oil trap box measures 6 by 8 by 8 and 1/4 quarter with a two and a half inch pipe thread in the bottom of the unit Air inlet is 17 and 1/4 inside 21 inches outside Fan blade is 16 inches in diameter, fan blade door opening is 12 1/4 high by 27 high HEPA filter door opening is 21 high by 27 wide Fan blade door opening is 12 high by 27 wide HEPA filter door opening is 21 high by 27 wide Lower inlet tube collector opening is 27 inches square upper inlet opening is 7 inches high by 27 inches wide There are 8 collector tubes on the right and left separated by a center channel section The inlet tubes measure 3-1/4 by 26 inches long with a four and one-half inch diameter baffle at the bottom shaped like a venturi with a series of holes around the radiused bottom The tubes have spiral inserts stagger welded the full length The lid and side panels of the upper half are lined with 1 inch thick dense foam and are in cased with separate frames All three doors are locked with a special key The filter deck is 24 inches wide by 48 inches long and 11 inches high in the closed position The filter deck hinges up and down and then telescopes out on you UHMW slide blocks Installed filters compress against two upper 24 by 24 frames that are also removable, these frames have rubber gaskets on both sides Formed lower legs are 29 inches long by 6 inch angle which bolt to the bottom box rails The bottom box rails have four sets of holes to allow different locating points for the legs Buyer is responsible for shipping costs we will load for free If you have questions or need more information please contact Randy at (319) 213-3229