Hickok 600 600a 6000 6000a Tester Calibration Service

US $190.50

Jamestown, North Carolina, United States
Jan 29th

Open on mobile:
QR code

We are Located in North Carolina All service performed by Degreed Electrical Engineers with over 36 years of experience designing and servicing Tube and Solid State equipment and Tube Testers. Bought a Hickok 600 800 6000 series tube tester on Ebay? Now what? It is most likely out of calibration like 99% of them being used. Our Company Ctech Elecrtonics will calibrate your tester according to Hickok standards, with multiple calibration tubes and a custom Gm simulator as references. The service assumes a working unit. The calibration consists of: Check operation of all switches and tube sockets, clean and tighten as required Check meter operation for sticking, zero set, and full scale current Replace all Electrolytic capacitors (as required at extra cost). Check all other capacitors and replace as required Check fuse lamps Check neon bulbs and operation of short detection ciruitry Check the 5Y3GT and #83 tubes Calibrate all voltages according to Hickok factory calibration procedures using a high accuracy voltmeter with proper impedance Calbrate and recheck the the Shunt/English dial in all three ranges 3k,6k and 15K using a custom Gm simulator and multiple 6L6 calibration tubes. If required provide new red dot marker positions and/or a sticker attached to the tester. Lightly clean front panel and case Check the unit with a variety of good and bad power and small tubes Provide a checklist and instructions on how to use the newly calbrated shunt dial. Your unit will operate as accurately as it possibly can. The calibration cost does not include the cost of any required parts replacement/labor, or labor needed to unsolder and resolder the halves of the shunt/english control to put the unit back into alignment. There is generally a $25.00 additional charge for this service. You will be notified if this is the case There will be an additional charge if parts need to replaced. Most times this is not required to get the unit to calibrate, if the unit is in working condition. Typical turn around is generally 5 - 7 working days. The shipping calculator is an estimate on return shipping. We will refund or bill you for the difference between this and the actual shipping charges, since we only charge actual shipping fees. If you would like to speak to us please call at 301 351-3781 or email us at sales@cteche.com We prefer Paypal. If you agree to replacement parts, we will bill you for the parts and labor via PayPal. In the event your unit can't be calibrated, or you decide you don't want to do it because of parts needed, you only pay a $49.00 bench fee and return shipping, and the balance of your payment will be refunded We are degreed Electrical Engineers and have been in the Audio and Electronic business for 30 years. We are also avid audiophiles. Check my feedback and bid with confidence. Please double box your tester and ship fully insured with tracking. If you have just purchased one off Ebay, have it shipped directly to us first, to save shipping charges. Your box will be used for return shipping. If your box is damaged, there will be a nominal charge fo packing and materials. Please include contact information in you package, as well as a description of what you think is wrong with your tester if other than calibration issues.. We also service the other Hickok testers, B&K and other brands of Testers as well. Email us with your requirments. sales@cteche.com We are a full service company offerting tubes, parts, equipment and repair services. Please visit our Ebay Store: