Hobart A200T Motor and Windings - - Includes Bearing, Capacitor, and Motor Gear, US $400.00 – Picture 0

Hobart A200T Motor and Windings - - Includes Bearing, Capacitor, and Motor Gear, US $400.00 – Picture 1

Hobart A200T Motor and Windings - - Includes Bearing, Capacitor, and Motor Gear, US $400.00 – Picture 2

Hobart A200T Motor and Windings - - Includes Bearing, Capacitor, and Motor Gear, US $400.00 – Picture 3

Hobart A200T Motor and Windings - - Includes Bearing, Capacitor, and Motor Gear, US $400.00 – Picture 4

Hobart A200t Motor And Windings - - Includes Bearing, Capacitor, And Motor Gear

US $400.00

Murfreesboro, Tennessee, United States
Jan 31st

Open on mobile:
QR code

Hobart 20qt Mixer Motor and Windings THIS auction is for the following: HOBART A200T MOTOR and Windings and Capacitor and included on motor is the MOTOR GEAR and Bearing. NOTE: There is a picture of the BACK of the MIXER housing -- I wanted to include that so you knew what type of casting this motor came out of, but see below the exact particulars such as ML#, SIZE, etc. to make sure this will fit your mixer! This came off of the following: HOBART MODEL: A200T ML: 104558 115 Volts 8.2 Amps 1725 rpm 1/2 HP motor PROBLEM: This motor has an "out of round" shaft at the very back of the motor where the motor has 2 small thin screws to secure it to the back of the mixer housing and as such it does not run correctly, however, one might be able to true the shaft and put a shim over the shaft and then put the bearing back in and that should take care of it. The shaft is supposed to be at 12mm, but we measured it and it is at 11.5mm on part of the shaft thus the "OUT OF ROUND" description. Please understand that I have taken this motor to a motor shop in Nashville, TN and verified the following that I have already stated. The windings IF that's all you need is worth what I'm asking!!! The motor is fixable, but I wanted to be upfront about everything that I know about this motor in stating that IF you just put this in another mixer, then what will happen is that the shaft will have a bit of a wobble because the back of the shaft somehow got out of round? Hope that makes sense. Email or call if you have further questions -- 615-738-0759 Jonathan RETURNS: NOT ACCEPTED as I have been upfront and honest in stating that this motor is in need of some repair to be used as a direct replacement. IF I have been unclear, then please contact me FIRST and I will explain to you everything that the motor shop told me.

Condition	For parts or not working : An item that does not function as intended and is not fully operational. This includes items that are defective in ways that render them difficult to use, items that require service or repair, or items missing essential components. See the seller’s listing for full details.
Seller Notes	“Signs of wear and tear inside there is some scoring on the inside of the windings from where the shaft hit the windings. Windings were tested and tested out fine. The Shaft of the motor toward the back bearing is out of round and would need to have a shim put around the back part of the shaft where the nuts go on and then a new bearing since there was play.”