National Instruments Ni Scb-68 Circuit Board- No Case- Good Condition 182470-01

US $1300

  • Boise, Idaho, United States
  • Jan 29th
This listing is for one (multiple available) National Instruments (NI) SCB-68 circuit board only as shown, not installed within Shielded Connector Block case. Boards have part # 182470-01, Rev B. The boards are used and in good condition, with moderate wear to screw terminals. Unit shown is one available and is representative of all, in condition, and with same part #/revision. This listing is for one each SCB-68 board, no other items are included. from NI (for unit with case- this listing is for PCB only, so "shielding" mentioned below will be at a minimum reduced where described)- The NI SCB-68 is a shielded I/O connector block for interfacing I/O signals to plug-in data acquisition (DAQ) devices with 68-pin connectors. Combined with the shielded cables, the SCB-68 provides rugged, very low-noise signal termination. It is compatible with single- and dual-connector NI X Series and M Series devices with 68-pin connectors. The connector block is also compatible with most NI E, B, S, and R Series DAQ devices. Shielded I/O connector block for use with 68-pin X, M, E, B, S, and R Series DAQ devices Screw terminals for easy I/O connections or for use with the CA-1000 2 general-purpose breadboard areas Onboard cold-junction compensation sensor for low-cost thermocouple measurements   The SCB-68 circuit board will be well packaged and sent in box via USPS Priority Mail, insured. the tracking # will be entered into ebay and paypal systems after shipment.
Condition Used :
An item that has been used previously. The item may have some signs of cosmetic wear, but is fully operational and functions as intended. This item may be a floor model or store return that has been used. See the seller’s listing for full details and description of any imperfections.
Seller Notes This listing is for a used SCB-68 circuit board only (removed from case) and is in good condition. The unit has moderate wear, noticeable mostly in screw terminals. The 68 pin connector is in excellent condition. The breadboard area is unused. The unit shown is representative of all units, in both condition, and with same part #/revision.

Directions

Similar products from Data Loggers and Data Acquisition Cards

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies