National Instruments NI SCB-68 Shielded Connector Block with E-Series Label, US $1100 – Picture 0

National Instruments NI SCB-68 Shielded Connector Block with E-Series Label, US $1100 – Picture 1

National Instruments NI SCB-68 Shielded Connector Block with E-Series Label, US $1100 – Picture 2

National Instruments NI SCB-68 Shielded Connector Block with E-Series Label, US $1100 – Picture 3

National Instruments NI SCB-68 Shielded Connector Block with E-Series Label, US $1100 – Picture 4

National Instruments Ni Scb-68 Shielded Connector Block With E-series Label

US $1100

Boise, Idaho, United States
Feb 28th

Open on mobile:
QR code

National Instruments (NI) SCB-68 Shielded Connector Block. Part # 182469-01, representative unit shown in photos (one of the units available- all in nearly identical condition, all have same part # as unit shown in photos). The units are in good working condition. The devices each have E-Series signal reference label installed inside lids. The units have only minor scratches and cosmetic wear that will not affect function or performance. The cable clamps are in new condition. The connector, jacksocket fasteners, and screw terminals are in very good condition. The breadboard areas are unused. The bottom of units have all feet and manufacturer labels as shown on representative unit. Information from NI- The NI SCB-68 is a shielded I/O connector block for interfacing I/O signals to plug-in data acquisition (DAQ) devices with 68-pin connectors. Combined with the shielded cables, the SCB-68 provides rugged, very low-noise signal termination. It is compatible with single- and dual-connector NI X Series and M Series devices with 68-pin connectors. The connector block is also compatible with most NI E, B, S, and R Series DAQ devices. Shielded I/O connector block for use with 68-pin X, M, E, B, S, and R Series DAQ devices Screw terminals for easy I/O connections or for use with the CA-1000 2 general-purpose breadboard areas Onboard cold-junction compensation sensor for low-cost thermocouple measurements The SCB-68 will be well packaged and sent in box via USPS Priority Mail, insured. the tracking # will be entered into ebay and paypal systems after shipment.

“This listing is for used SCB-68 shielded connector blocks, one each, in good working condition. The units have minor cosmetic scratches and wear which will not affect function or performance. All have jacksocket fasteners to attach to cable jackscrews to secure the connection. The breadboard area of circuit boards are unused. The units comes with E-Series signal reference label installed inside lids as shown in representative unit photo (one of those available). The exterior side screws are not included. The bottom of unit has all four feet and labeling. The cable clamps appear unused but may have slight indentations.”

Brand	National Instruments
Country/Region of Manufacture	United States
Model	SCB-68