National Instruments Ni Scb-68 Shielded Connector Block E-series Label, Manuals

US $135.00

  • Boise, Idaho, United States
  • Jun 9th
National Instruments (NI) SCB-68 Shielded Connector Block. Part # 182469-01, same unit shown in photos. The devices has new unused E-Series signal reference label for installation inside lid. Also included is an SCB-68 User/Installation Manual, and a E-Series User Manual. The SCB-68 has minor scratches and cosmetic wear that will not affect function or performance. The cable clamps are in new condition. The connector, jacksocket fasteners, and screw terminals are in very good condition. The breadboard areas are unused. The bottom of units have all feet and manufacturer labels as shown. Information from NI- The NI SCB-68 is a shielded I/O connector block for interfacing I/O signals to plug-in data acquisition (DAQ) devices with 68-pin connectors. Combined with the shielded cables, the SCB-68 provides rugged, very low-noise signal termination. It is compatible with single- and dual-connector NI X Series and M Series devices with 68-pin connectors. The connector block is also compatible with most NI E, B, S, and R Series DAQ devices. Shielded I/O connector block for use with 68-pin X, M, E, B, S, and R Series DAQ devices Screw terminals for easy I/O connections or for use with the CA-1000 2 general-purpose breadboard areas Onboard cold-junction compensation sensor for low-cost thermocouple measurements   The SCB-68 with documentation will be well packaged and sent in box via USPS Priority Mail, insured. the tracking # will be entered into ebay and paypal systems after shipment.
This listing is for used SCB-68 shielded connector block, in good working condition. The unit has minor cosmetic scratches and wear which will not affect function or performance. The breadboard area of circuit board is unused. The unit comes with new unused E-Series signal reference label for installation inside lid. Also included is SCB-68 User/Installation Manual, and E-Series User Manual as shown. The SCB-68 exterior side screws are included/installed as shown. The bottom of unit has all four feet and labeling. The cable clamps appear unused but may have slight indentations.
Brand National Instruments
Country/Region of Manufacture United States
Model SCB-68

Directions

Similar products from Data Loggers and Data Acquisition Cards

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies