New!! Foxboro Magnetic Flowtube 2893-sbbb-phf-g

US $390

Amherstburg, Ontario, Canada
May 29th

Open on mobile:
QR code

Brand new, no box. no shelf wear. 6 mm (1/4 in) AISI Type 310 Stainless Steel (310 ss) Schedule 40 Pipe ANSI Class 150 RF Flange, AISI Type 316 stainless steel (316 ss) pfa (Perfluoroalkoxy) lining. Hastelloy C - Flat Head Electrode Pulsed dc from 896 Transmitter (Series Coils Only)(b) General Purpose, NEMA 4X Housing - Remote Mounted Transmitter GENERAL PURPOSE, NEMA 4X, WEATHERPROOF CONSTRUCTION The 2800 Series Flowtube is designed to operate in harsh outdoor or in-plant environments. The General Purpose housing (Code -G) is weatherproof as defined by IEC IP65 and provides the environmental and corrosion-resistant protection of NEMA Type 4X. The Flowtube can also be provided for use in a total/accidental submergence installation, or in installations where high humidity and condensate can create problems, as described in the paragraphs below. Total/Accidental Submergence Construction This construction consists of special RTV sealing techniques for continuous operation under 9 m (30 ft) of water maximum. A supply of RTV 600 two-part potting compound is included for the user to seal the signal and power connections during installation. This housing construction is selected using Housing Code -N. High Humidity/Condensate Construction This construction consists of special sealing techniques to help prevent internal formation of condensate in applications involving cold process temperature and warm ambient. Select using Housing Code -C. DESIGNED FOR WIDEST VARIETY OF LIQUIDS A choice of ptfe, pfa, or polyurethane lining material, and a selection of electrode materials and shapes, enables these flowtubes to handle a wide variety of liquids ranging from water to slurries, and sticky, abrasive, and highly corrosive processes. FLOWTUBE CALIBRATION All flowtubes are wet calibrated to verify their specified accuracy with traceability to the U.S. National Institute of Science and Technology. The calibration produces a calibration factor that is needed to accurately configure the transmitter. The calibration factors for use with MagEXPERT or an E96 Transmitter are different. The selection of calibration type is done in the Flowtube Model Code (refer to Model Code section - Nominal Supply Voltage and Frequency). If the transmitter type is changed later, the calibration factor can be converted by calculation. This calibration factor, however, will be slightly less accurate than that derived by wet calibration. MULTI-AGENCY CERTIFICATION FOR HAZARDOUS LOCATIONS These flowtubes have been designed to meet the approval requirements of many agencies for use in hazardous locations. Refer to “Electrical Safety Specifications” section.