Proplumber Plastic And Steel Pressure Switch 30-50 Psi Ppsl3050

US $750

  • Amherst, Ohio, United States
  • Nov 5th
 ProPlumber Plastic and Steel Pressure Switch Plastic and Steel Pressure Switch Signals the pump to start when the water system drops to 30 PSI (factory set) and stops at 50 PSI (factory set) Can be wired 115-volt or 230-volt This switch is equipped with a low-level cut-off arm that automatically shuts off a well pump when there is a dramatic decrease in pressure, such as a leak in the discharge pipes or a faulty pressure tank When first running the pump after installing the switch, hold the lever in the start position until pressure reaches 30 PSI For use with submersible well or jet pumps (that can create up to 50-lbs of pressure) Motor wires are connected to the 2 middle posts (color does not matter); Breaker box wires are connected to 2 outside posts (color does not matter) 2-spring design allows for adjustment of cut-in and cut-out pressure settings Adjustments to springs should only be made by users with good knowledge of well systems and tank must be in good condition in order for this to work properly See 'Installation Manual' and 'How to Manual' for more helpful information

Directions

Similar products from Pump Accessories & Spare Parts

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies