Radionics D7212 Panel

US $50.00

Austin, Texas, United States
Jan 30th

Open on mobile:
QR code

Points The Radionics D7212 Control/Communicator panel provides up to 48 separate points of protection. Point programming parameters determine the panel’s response to open and shorted conditions on the point’s sensor loop. Points are programmed individually with several options to custom-fit the protection to your installation. Points 1 to 8 are located on the D7212 circuit board (on-board points). They are standard sensor loops. The remaining 40 off-board points are POPIT ( Point of Protection Input T ransponder) points. Each off-board point requires a POPIT module. D8127 POPIT modules require the D8125 POPEX module. The D8128A OctoPOPIT module combines eight POPITs in a single module and does not require the D8125 POPEX module. Communicator The Radionics D7212 Control/Communicator panel uses a built-in digital communicator to send reports to the receiver. The panel transmits reports in either the Modem II or BFSK format. Your D6500 receiver's MPU and line cards must have software revision 6.00 (or greater) installed to accept Modem II reports from the D7212. Power your receiver down and up to print the software revision numbers. The D7212 connects to an RJ31X jack for phone line seizure. Connection to the RJ31X complies with FCC regulations for using the public telephone network. You can program the panel to direct reports to four separate phone numbers. Adding the D128 Dual Phone Line Switcher module allows you to connect and supervise a second phone line.

Condition	Used : An item that has been used previously. The item may have some signs of cosmetic wear, but is fully operational and functions as intended. This item may be a floor model or store return that has been used. See the seller’s listing for full details and description of any imperfections.
Seller Notes	“Working in good condition.”