Sherline1066 - Er Collet-to-sherline Chuck Arbor 1/2" Shank New

US $410

  • Vista, California, United States
  • Jun 7th
Made in the USA! One 1066 arbor When using a large lathe with 5C, ER or other large collets it is sometimes helpful to have a way to change to a small chuck quickly. These adapters have either a 1/2" shank (1066) or a 5/8" shank (1065). On the other end is a 3/4-16 thread that accepts any Sherline 2.5" or 3.1" chuck. This allows you, without changing your spindle or going to another machine, to quickly install a Sherline 3- or 4-jaw chuck. Just insert the shank of the adapter attached into a 1/2" or 5/8" collet. Now you can chuck up parts that could not be easily held in a collet. T.I.R. of the adapter is specified to be 0.0005" (0.013mm) or less. The unhardened steel adapters have a black oxide finish to prevent rust. ScaleAutoArt is a Sherline approved dealer.  Shipping is direct from Sherline and usually ships UPS Ground Service w/in 48 hours after receiving payment.  Note:  All purchases made after 11:00 am Eastern time will be processed the following day. Sherline Products offer the highest quality Micro Lathes/ Mini Lathes and Micro Mills /Mini Mills and accessories available today and are made here in the USA.

Directions

Similar products from Other Electronic Components & Spare Parts

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies