Simpson Strong-tie Titen Hd Screw Anchors 5/8 X 6" 4 Pack Of 10/qty40 Thdb62600h

US $230

San Pablo, California, United States
Jun 21st

Open on mobile:
QR code

BRAND NEW BOX 4 pack of 10/qty40 Simpson Strong-tie Titen HD Screw Anchor 5/8 x 6" Zinc THDB62600H The Titen HD screw anchor is a patented, high-strength screw anchor for concrete and masonry. The anchor offers high-strength performance and low installation torque with no secondary setting. For use in dry, interior, non-corrosive environments or temporary outdoor applications, the Titen HD has been tested to offer industry-leading performance in cracked and uncracked concrete - even in seismic loading conditions. Features: Code-listed under the current IBC/IRC in accordance with AC193 for cracked concrete applications per ICC-ES ESR-2713 Code-listed under the current IBC/IRC in accordance with AC106 for masonry applications per ICC-ES ESR-1056 Thread design undercuts to efficiently transfer the load to the base material Specialized heat-treating process creates tip hardness for better cutting without compromising the ductility that helps prevent breakage No special drill bit needed: Designed to install using standard-sized ANSI tolerance drill bits Installs with 50% less torque: Testing shows that when compared to competitors, the Titen HD requires 50% less torque to be installed in concrete Hex-washer head: Requires no separate washer and provides a clean installed appearance. Removable: Ideal for temporary anchoring (e.g. formwork, bracing) or applications where fixtures may need to be moved. Re-use of the anchor to achieve listed load values is not recommended. Codes: ICC-ES ESR-3037 (concrete); IAPMO UES ER-240 (carbon steel in CMU); City of Los Angeles RR25891 (concrete), RR25936 (carbon steel in CMU); Florida FL 15730; UL File Ex3605; FM 3043442 and 3047639 Material: Carbon steel, heat treated Finish: Zinc plated or mechanically galvanized Installation: Caution:Oversized holes in the base material will reduce or eliminate the mechanical interlock of the threads with the base material and will reduce the anchor's load capacity. Use a Titen HD screw anchor one time only. Installing the anchor multiple times may result in excessive thread wear and reduce the load capacity. Drill a hole in the base material using a carbide drill bit the same diameter as the nominal diameter of the anchor to be installed. Drill the hole to the specified embedment depth plus 1/2" minimum to allow the thread tapping dust to settle and blow it clean using compressed air. Overhead installations need not be blow clean. Alternatively, drill the hole deep enough to accommodate embedment depth and dust from drilling and tapping. Insert the anchor through the fixture and into the hole. Tighten the anchor into the base material until the hex washer head contacts the fixture. Do not use impact wrenches to install into hollow CMU. 1. Zinc plating meets ASTM B633, SC1 2. Length is measured from the underside of the head to the tip of the anchor.