Trimble Lassen Sq Low Power Micro 8 Channel 3.3v Gps Module 1pps

US $370

China, China
Jan 29th

Open on mobile:
QR code

Trimble Lassen SQ Low Power Micro 8 Channel 3.3v GPS module 1pps Trimble Lassen SQ Low Power, Micro Sized 8 Channel GPS Receiver Ideal Solution For Mobile Applications 3.3V for battery powered apps Trimble quality at low cost 8-channel operation Operating temp -40° to +85°C Next-generation RF technology 26 mm x 26 mm x 6 mm Sized for portable devices TSIP, TAIP & NMEA support Different antennas available Starter kit available Ultra-low power: 90mW @ 3.3V Datasheet/Manual: Datasheet in PDF format Manual in PDF format Introduction Trimble's Lassen® SQ module adds complete GPS functionality to your mobile product in a postage-stamp-sized footprint with ultra-low power consumption. The module is designed for portable handheld, battery-powered applications such as cell phones, pagers, PDAs, digital cameras, and many others. Using Trimble's breakthrough FirstGPS™ architecture, the module delivers complete position, velocity and time (PVT) solutions for use in the host application. The Lassen SQ module uses minimal power and space and delivers a robust, reliable PVT solution. The Lassen SQ module is the only stamp-sized GPS product with the three most popular standard protocols: TSIP (Trimble Standard Interface Protocol), TAIP (Trimble ASCII Interface Protocol) and NMEA 0183. The module is enclosed within a metal shield for ease of handling. The shield acts as a protective case. FirstGPS Hardware The FirstGPS architecture consists primarily of two integrated circuits and FirstGPS firmware. This technology enables the Lassen SQ to achieve the unique combination of both ultra-low power usage and micro-size in the same unit. Hardware The Lassen SQ module packages this architecture in a tiny form factor, (approximately 26 mm x 26 mm, including the metal shield). It typically requires only 110 mW of power (at 3.3 VDC). Total typical power usage, including the Trimble 3.3 VDC miniature antenna, is =143 mW. The highly integrated module is a miniature board containing a GPS hardware core based on Trimble's Colossus RF ASIC and IO-TS digital signal processor (DSP) design and a 32-bit RISC CPU. The module offers onboard data storage in flash memory for complete processing capability. Antennas The Lassen SQ module is compatible with active, 3.3 VDC antennas. Three such antennas are available from Trimble and are recommended for use according to your application: An ultra-compact embedded antenna, approximately the same size as the module itself. This antenna is unpackaged, for easy integration into mobile applications. A compact, unpackaged antenna slightly larger than the ultra-compact model above. A compact, packaged antenna with magnetic mount for flexible, movable installation. Getting started The Lassen SQ Starter Kit provides everything you need to get started integrating state-of-the-art GPS capability into your application. Specification Key Features: 8-channel simultaneous operation Ultra-low power consumption: less than 110 mW @ 3.3 V Antenna open and short circuit detection and protection Compact size: 26 mm W x 26 mm L x 6 mm H Supports NMEA 0183, TSIP, TAIP, DGPS protocols Trimble quality at low cost Performance: General: L1 (1575.42 MHz) frequency, C/A code, 8-channel, continuous tracking receiver, 32 correlators Do you require a 12 channel receiver? Look at the Lassen iQ instead. Update rate: TSIP @ 1 Hz; NMEA @ 1 HZ, TAIP @ 1 HZ Accuracy: Horizontal: <6 meters (50%), <9 meters (90%) Altitude: <11 meters (50%), <18 meters (90%) Velocity: 0.06 m/sec PPS: ±95 nanoseconds Acquisition: Hot Start: <14 sec (50%), <18 sec (90%) Warm Start: <38 sec (50%), <45 sec (90%) Cold Start: <90 sec (50%), <170 sec (90%) Cold start requires no initialization. Warm start requires last position, time and almanac are saved in battery back-up memory. Hot start requires that the ephemeris also saved. Reacquisition: <2 sec. (90%) Dynamics: Acceleration: 4g (39.2 m/sec2) Motional jerk: 20 m/sec3 Operational limits: Altitude <18000m or velocity <515m/s (COCOM limit) Either limit may be exceeded but not both Interface: Connectors: I/O: 8-pin (2x4) male header, micro terminal strip ASP 69533-01 or similar RF: Low-profile coaxial connector H.FL-R-SMT (10), 50 Ohm Serial Port: 1 serial port (transmit/receive) PPS: 3.3 V CMOS-compatible, TTL-level pulse Once per second with the rising edge of the pulse synchronized with UTC Protocols: TSIP @ 9600 baud, 8 Bits NMEA 0183 v3.0, selectable baud rate 8 Bits TAIP @ selectable baud rate, 8 Bits NMEA Messages: GGA, VTG, GLL, ZDA, GSA, GSV and RMC Messages selectable by TSIP command; selection stored in flash memory Electrical: Prime power: +3.0 VDC to +3.6 VDC (3.3 V typ.) Power consumption: GPS board only: 110 mW @ 3.3 V With embedded antenna: 143.3 mW @ 3.3 V Backup power: +2.5.VDC to +3.6VDC Ripple Noise: Max 60 mV, peak-to-peak from 1 Hz to 1 MHz Antenna Fault Protection: Short-circuit detection and protection Interface Characteristics: Serial ports/1PPS: CMOS TTL levels Supported Protocols: TSIP @ 9600 baud, 8-Odd-1 (configurable) TAIP @ 4800 baud, 8-None-1 (configurable) NMEA 0183 v2.1 @ 4800 baud, 8-None-1 (configurable) NMEA messages: GGA, VTG, GLL, ZDA, GSV, GSA and RMC Messages selectable by TSIP command; selection stored in non-volatile memory Other: Dimensions: 3.25" x 1.25" x 0.40" (82.6mm x 31.2mm x 10.2mm) without connectors Weight: 0.7 oz. (19.6 g) without optional shield Connectors: RF: SMB I/O: 8-pin (2x4), 0.100” header ROHS Status: This product is lead free/ROHS compliant. -------------------- over 150 in stock.qty price contrac me --- ship by hong kong post or ems worldewide ------------ all have been tested. -------------- On Mar-05-09 at 09:41:44 PST, seller added the following information: Sellers: Delight buyers. Get your own map of past buyers. On Mar-10-09 at 12:52:14 PDT, seller added the following information: On Jun-27-09 at 21:55:33 PDT, seller added the following information: eBay Cross Border Trade powered by Channel Effect