16-channel 12-bit Pwm Servo Driver For Raspberry Pi Zero

US $13.86

  • Swanton, Vermont, United States
  • Jul 7th
Description 16-channel, 12-bit PWM controller Suitable for driving LEDs and radio control servos Output frequency is programmable Maximum input voltage: 5.5V when PWR Link is not bridged. Maximum current on each PWM pin 22mA The 16-Channel 12-Bit PWM Servo Driver for Raspberry Pi Zero is a 16-channel, 12-bit PWM controller for the Raspberry Pi, suitable for driving LEDs and radio control servos. The board is based around PCA9685 PWM I2C LED controller IC from NXT and can drive each of the 16 outputs with 12 bit (4096 steps) duty cycle from 0% to 100%. The output frequency is programmable from a typical 40Hz to 1000Hz. Each output driver is programmed to be either open-drain with a 22 mA current sink capability at 5 V or totem pole with a 22 mA sink, 10 mA source capability at 5 V. 220R current limiting resistors are used on each channel allowing you to connect servos or LEDs directly to the outputs.
Condition:
New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...
Brand AB Electronics UK
Type AB Electronics UK
MPN ServoPWMPi
UPC Does not apply

Directions

Similar products from Other Motor Speed Control Systems & Amplifiers

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies