1pc 84*48 Lcd Display Screen Modul Module Fur Arduino Nokia 5110 Diy

US $120

  • ??, ???, China
  • Jan 29th
1PC 84*48 LCD Display Screen Modul Module fur Arduino Nokia 5110 DIY 1. VCC - positive power supply (3.3v)  2. GND - Power negative  3. SCE - Chip Select  4. RST - Reset  5. D / C - data / instruction selection  6. DN <MOST> - serial data line  7.SCLK - Serial Clock Line  8. LED - backlight control This module has the following features: 84 x48 dot matrix LCD, can display the line 4 Chinese characters, Using serial interface communicate with main processor, number of interface signal lines are greatly reduced, signal lines, including power supply and ground, only eight. Support for multiple serial port communication protocol (e.g., AVR MCU SPI, MCS51 mode, etc.) and serial port, transmission rate up to 4 MBPS, can be written to the display data at full speed, no waiting time. Low and printed edition can be connected through the conductive adhesive module, rather than connecting cable, using the metal hook on the module module can be fixed on the PCB, and therefore very easy to install and replace. Low LCD controller/driver chip is bound to the chip, LCD module of small size. With low voltage power supply, normal according to the working current of under 200 mu A, and has the power mode. 

Directions

Similar products from Display Modules & Monitors

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies