2.5mpa Pump Hydraulic Manual Pipeline Testing Pump

US $2600

  • Toronto, Canada
  • Jan 30th
?????? 1 Hydraulic Manual Testing Pump Directions for using: 1.connect the water hose to the measured water pipeline(Note:connect sealed) 2.fill the measured pipe with water, make air out and turn off the switch 3.make the tank filled with water,lift the rod,and then begin to test pressure 4.stop pressing when the pressure reach the need 5.after stopping the pressure , if the pressure indicated on the pressure gauge does not drop ,      you can prove that the pipeline pressure resistance is good , or the measured pipe is leakage. Normal testing pressure  25KG=2.5Mpa/cm2 Failure causes and remedies: one.When the handle moves up, do not suck up water  1.Check the suction pipe for junk clogging  2.Check whether the switch is tightened two.the movement is weakness when the handle up and down  1.Check whether the switch is tightened  2.Check whether the piston shaft seal is damaged  3.check the one-way valve for the junk three.the pressure displayed isn't stable  1.Pipe joints or water leaks , replace the seals  2.Table rod junction leakage , replace seals  3.Gauge damage , repair gauge SPECIAL NOTE: Ban in a workplace with acid and alkali, corrosive substances Item# Description QTY 134145 Pressure Testing  Pump 1

Directions

Similar products from Hydraulic Pumps

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies