(200) 1/4" X 1" Hammer Drive Concrete Anchor - Zinc- Free Shipping!!!!!

US $58

  • Manhasset, New York, United States
  • Jun 7th
 1/4" Diameter   x  1" length- Mushroom Head Hammer Drive Anchor                              200 pcs. (Unit cost-  $0.18/pc. )            Sometimes referred to as ZAMAC Nail in Anchors , Hammer Drive Pin Anchors, Hammer set nail anchors they are made from corrosion resistant ZAMAC alloy and can be used in concrete, block, brick or stone. They are quickly and easily hammered into pre-drilled holes.The nail acts as an expansion and locking pin,and they're virtually tamper-proof. The integral unit is made of zinc alloy with hardened steel nail, which is zinc plated per ASTM B633, SC1, Type III. Caution: Not for use in overhead applications. Installation: Drill a hole in base material using a carbide drill bit the same diameter as the nominal diameter of the anchor to be installed. Drill the hole to specified embedment depth, plus 1/4" for pin extension, and blow hole clean using compressed air. Alternatively, drill the hole deep enough to accommodate embedment depth and dust from drilling. Position fixture and insert Hammer Drive anchor. Tap with hammer until flush with fixture, then drive pin until flush with top of head.

Directions

Similar products from Clamp Tools & Anchor Expanders

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies