4 - 1 Gallons Of Kemiko Neutra Clean Concrete Stone Cleaner Dirt Gone Concrete

US $290

Pompano Beach, Florida, United States
Jun 6th

Open on mobile:
QR code

KEMIKO® NEUTRA CLEAN Water Base Cleane THIS IS FOR ONE BOX OF: 1 Gallon x 4 Benefits Include: • LEED Compliant • Low Odor - Low VOC • Excellent All Purpose Cleaner Commonly Found In: • Kitchens • Grocery Stores • Restaurants • Walkways • Interior and Exterior Surfaces Requiring Cleaning Description: KEMIKO® NEUTRA CLEAN is an industrial strength, low VOC, high performance water base sodium metasilicate cleaner for the preparation of bare concrete and coated substrates. KEMIKO® NEUTRA CLEAN is a water viscosity, single component product with a pleasant citrus odor that does not contain any hazardous solvents, is concentrated and diluted with water, and prepares the surface for staining, sealing and re-coating. Applications: KEMIKO® NEUTRA CLEAN is typically applied to concrete substrates to remove deleterious matter such as grease, grime, soil, wall plaster, and other construction related residue. KEMIKO® NEUTRA CLEAN is applied with commercially available pressure sprayers, steam cleaners, or simply poured onto floor and worked into the surface with a stiff bristle brush or floor machine. Typical applications include commercial kitchens, grocery stores, restaurants, showroom floors, walkways, and many other interior and exterior surfaces requiring cleaning. Surface Preparation Bare Concrete: Use KEMIKO® NEUTRA CLEAN to remove visible oil, grease, sludge, stain residue and any other contaminants that may impact a Kemiko, Rembrandt or Sta-Crete product application. Apply Kemiko® Neutra Clean to substrate, allow 2-3 minutes to “wet in” then scrub using stiff bristle brooms, brushes or heavy duty fl oor scrubbing machines. DO NOT ALLOW KEMIKO® NEUTRA CLEAN TO DRY ON SURFACE. Once the scrubbing action is completed, rinse surface with clean fresh water. Check surface again to insure all deleterious matter is removed. Repeat application of KEMIKO® NEUTRA CLEAN if necessary. Surface shall be allowed to dry thoroughly prior to any staining, sealing or coating application. Existing Coatings/Sealers: Apply small amount of KEMIKO® NEUTRA CLEAN on surface, allow to stand 5-10 minutes and rinse with fresh water. If existing coating or sealer is not affected (removed) by Kemiko® Neutra Clean, proceed as instructed above for surface preparation. ACRYLIC SEALERS MAY BE COMPROMISED OR DESTROYED WITH KEMIKO® NEUTRA CLEAN. Make sure to check compatibility prior to application. Application Methods Brush - Use top-quality nylon bristle brush for best film properties. Floor Machine - Electrical rotary type utilizing soft pads or black, green or white scouring pads for heavy duty cleaning. Spray – Low pressure “Hudson” type commercial sprayers to apply product followed by scrubbing action. Environment – Apply between 50°F. – 100°F. and 5°F. above dewpoint. Do not store in direct sunlight. Protect from freezing. Do not apply to wet or frosted surfaces. Safety – May be irritating to eyes and skin! Wear gloves and eye protection during application. Respiratory protection should be used if airborne concentrations exceed acceptable levels and to insure applicators health. Typically a NIOSH/MSHA certified respirator with organic vapor/HEPA filters should be worn.