5pck Toggler Snaptoggle Zinc-plated Steel Toggle, 1/4"-20 Size, 3/8"-3-5/8" Long

US $8.47

  • Cleveland, Ohio, United States
  • Feb 17th
Stop replacing anchors every time you change a fixture. When you unthread the screw, these anchors stay put. To install, push the toggle through a drilled hole and pull the anchor back toward you until the toggle rests flush against the wall. Then slide the cap up to the wall and snap off the straps. Next, position your fixture, insert a machine screw (not included), and tighten. Minimum screw length equals wall and fixture thicknesses plus 1/2". Anchor body is plastic. Class 2B thread fit. Ultimate pull-out and shear strengths are based on tests in concrete block. Ultimate shear strength is the force the side of an anchor can withstand before breaking. Warning! Allowable pull-out and shear strength are 25% of ultimate values or less, as required by building authorities.
Condition:
New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...
Brand Toggler
Usable Length 3/8"-3 5/8"
Model Snaptoggle
Drill Size 1/2"
MPN 97802A316
Ultimate Pull Out Strength 1,000 lbs
For Screw Size 1/4"-20
Ultimate Shear Strength 1,000 lbs

Directions

Similar products from Clamp Tools & Anchor Expanders

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies