703100 Cnc Operator Interface Control Station Kit E-stop Feed Hold Cycle Start

US $37.00

  • New Hudson, Michigan, United States
  • Jun 9th
   703100 CNC Operator Interface Control Station Box kit I have used commercial/industrial CNC machines for many years and have also participated in the growth of the Home/Hobby CNC machine business.  One of the features lacking in most low cost machines is a usable start, hold, stop button.  If  you want to run several parts, the operator has to click a keyboard or screen soft key to run each part.  This can take as long as running the entire part operation and provides a lot of opportunity for operator error.  We are using this control in our own shop on a recently converted mini-mill and a cnc converted Hardinge lathe.  It saves a lot of confusion and irritation when an operator clicks the wrong key or control on the screen.  He pushes start to run his part and hold or e-stop if something bad happens.  It does not matter if he is left or right handed. Includes E-stop, Feed Hold, and Cycle Start buttons.  Prewired and tested. May be used with common ground or  5v-24v control logic. Includes 6 foot M-M cable and matching female panel connector. Estop, Red, is SPST, NC, Push to Latch Open, Twist to release Feed Hold, Yellow, is SPDT,NC/NO, Press to latch, Press again to Release Cycle Start, Green, is SPDT,NC/NO Press Momentary Box is wired with feed hold and Cycle start wired as Normally Open, and all switches use a common wire.   The box connector, control cable and panel connector are 6 wires, so user can rewire the switches independantly if desired.  Wire codes as shipped, Blue is common, Red is E-stop, Yellow is Feed Hold, and Green is Cycle Start.  The box lid can be rotated 180 degrees to provide cable entry near the estop or the start buttons.  Wiring Schematic  PDF reader required Female Panel connector mounts in a 1/2 dia hole with 2, 1/8 dia holes equidistant on either side and 3/4 inch spacing between them.  Tapped for 4-40 x 3/8 long mounting screws, 2 are included User is responsible for interfacing to their CNC control system.        
Condition:
New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...
Brand IMService
Country/Region of Manufacture United States
Model OIB
Country of Manufacture United States
MPN 703100

Directions

Similar products from Linear Actuators & Bracket Stroke

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies