Accupro snap gage machinist 6-piece telescoping set with case 5/16" to 6" range, US $25.00 – Picture 0

Accupro snap gage machinist 6-piece telescoping set with case 5/16" to 6" range, US $25.00 – Picture 1

Accupro snap gage machinist 6-piece telescoping set with case 5/16" to 6" range, US $25.00 – Picture 2

Accupro Snap Gage Machinist 6-piece Telescoping Set With Case 5/16" To 6" Range

US $25.00

Citrus Heights, California, United States
Mar 3rd

Open on mobile:
QR code

- Thanks for looking! I'll be listing additional machinist, gunsmithing, milling, lathe, precision measurements gear/equipment, micrometers (id = inside diameter; od = outside diameter) in next few days - This item is in like-new condition - Buy Now payment due immediately. Paypal only. - Can deliver locally in Sacramento area; you'll still need to pay $5 for gas. Reach out to me before auction ends. - no Returns - domestic shipping will be either Post Office Priority or United Parcel Service ground. Item will be shipped within 3 days of cleared payment and includes insurance if shipped domestically (included in handling/shipping cost - per ebay policy which I was recently forced to read...again...). - International bidders: shipping will likely be International 1st Class and will cost you more than $15 (USD); contact me for shipping quote. Details: - 6-piece telescoping gauge set with factory hard travel/storage case. - snap gauges are used for precision measurements by machinists, gun smiths (gunsmithing), and others. - used to determine exact size to 1,000th of an inch (I think...you guys probably know for sure) of holes, slots, bores, recesses, and so forth... Piece #1: Range: 5/16"- 1/2" (3mm to 12mm) Piece #2: Range: 1/2"- 3/4" (12.mm to 19mm) Piece #3: Range: 3/4"- 1 1/4" (19mm to 32mm) Piece #4: Range: 1 1/4"- 2 1/8" (32mm to 54mm) Piece #5: Range: 2 1/8"-3 1/2" (54mm to 90mm) Piece #6: Range: 3 1/2"- 6" (90mm to 150mm) Additional Information: Telescoping gages are used to gage large holes and to measure inside distances. These gages are equipped with a plunger that can be locked in the measuring position by a knurled screw or locking nut in the end of the handle. Maximum measuring capacity is 6 inches. Measurements must be calipered on the gage by a micrometer, as in the case of the small hole gages. They are also used when measurements cannot be taken with a standard micrometer. Telescoping gages are particularly adaptable for roughly bored work and odd sizes and shapes of holes. To use the telescoping gage loosen the knurled locking nut at the end of the handle. Compress the plungers, place them into the hole to be measured, release the turning handle screw, slightly tilt the telescoping gage, and rock it back and forth slightly, while at the same time gradually tightening the turning handle screw. Remove the gage from the hole. Take measurements only once. Repeated attempts will produce an inaccurate reading. Measure the gage setting with an outside micrometer.

“Owned by my machinist and gunsmithing father (he has moved on now). Appear to be in like-new condition.”

Type	Bore
Brand	Accupro