Actuonix Pq12-r Linear Actuator 20mm, 100:1, 6v, Rc Control

US $73.50

Swanton, Vermont, United States
Jul 12th

Open on mobile:
QR code

Description Actuonix PQ12-R Actuator 20mm, RC Control Input voltage: 6 VDC Peak power point: 40 N @ 6 mm/s Gear ratio: 100:1 Max speed (no load): 10 mm/s Stall current: 550 mA The PQ12-R Linear Actuator 20mm, 100:1, 6V, RC Control operates as a direct replacement for standard rotary servos. It uses the same standard 3 wires connectors, ground, power, and control. Regardless of how you drive your servos, driven with an RC receiver, an Arduino board, or a VEX micro-controller, the PQ12-R servo perfectly replaces a regular servo with the added benefit of providing linear motion. The -R actuators are ideally suited to use in robotics and radio control models. They are a direct replacement for regular radio-controlled hobby servos. The desired actuator position is input to the actuator on lead 1 as a positive 5 Volt pulse width signal. A 2.0 ms pulse commands the controller to fully retract the actuator and a 1.0 ms pulse signals it to fully extend. If the motion of the actuator, or of other servos in your system, seems erratic, place a 1–4Ω resistor in series with the actuator’s red V+ lead wire. The PQ12–R Linear Servos are designed to work with typical RC receivers and battery packs. Consequently, they also are compatible with Arduino control boards, VEX Microcontrollers, and many other similar boards designed for robotics. Specifications Gearing ratio: 100:1 Peak power point: 40 N @ 6 mm/s Peak efficiency point: 20 N @ 8 mm/s Max speed (no load): 10 mm/s Max force (lifted): 50 N Max side Load: 10 N Back drive force: 35 N Stroke: 20 mm Input voltage: 6 VDC Stall current: 550 mA Mass: 15 g Operating temperature: -10 to +50 °C Positional accuracy: ±0.1 mm Duty Cycle: 20% Audible noise: 55 dB @ 45 cm Ingress protection: IP-54 Feedback potentiometer: 5kΩ ±50% Limit switches: Max. current leakage: 8uA What's Included 1 x PQ12-R Linear Actuator 20mm, 100:1, 6V, RC Control 1 x Accessories set

Condition:	New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...	Brand	Actuonix
Type	Actuonix
MPN	PQ12-100-06-R
UPC	Does not apply