Adafruit 2.8" TFT LCD Display Touch Screen Arduino Shield w/Resistive Touch, US $35.00 – Picture 0

Adafruit 2.8" TFT LCD Display Touch Screen Arduino Shield w/Resistive Touch, US $35.00 – Picture 1

Adafruit 2.8" TFT LCD Display Touch Screen Arduino Shield w/Resistive Touch, US $35.00 – Picture 2

Adafruit 2.8" Tft Lcd Display Touch Screen Arduino Shield W/resistive Touch

US $35.00

Keene, New Hampshire, United States
Jun 9th

Open on mobile:
QR code

This listing is for one Brand new in an opened box Adafruit 2.8" TFT LCD Display Touch Screen Arduino Shield w/Resistive Touch adafruit product id 376 . DESCRIPTION Spice up your Arduino project with a beautiful large touchscreen display shield with built in microSD card connection. This TFT display is big (2.8" diagonal) bright (4 white-LED backlight) and colorful (18-bit 262,000 different shades)! 240x320 pixels with individual pixel control. It has way more resolution than a black and white 128x64 display. As a bonus, this display has a resistive touchscreen attached to it already, so you can detect finger presses anywhere on the screen. The shield is fully assembled, tested and ready to go. No wiring, no soldering! Simply plug it in and load up our library - you'll have it running in under 10 minutes! Works best with any classic Arduino (UNO/Duemilanove/Diecimila). This shield does work with the Mega Arduinos but its going to be half the speed of the Uno-type boards because of the way the Mega rearranges all the pins (there is no way to get around this!) This shield is not Leonardo-compatible This display shield has a controller built into it with RAM buffering, so that almost no work is done by the microcontroller. The shield does require a lot of pins: 12 lines total for the display, 13 total if you use the microSD card Of course, we wouldn't just leave you with a datasheet and a "good luck!" - we've written a full open source graphics library that can draw pixels, lines, rectangles, circles and text. We also have a touch screen library that detects x, y and z (pressure) and example code to demonstrate all of it. The code is written for Arduino but can be easily ported to your favorite microcontroller! If you are not using an Arduino-shaped microcontroller, check out our 2.8" TFT breakout board which can be easily wired up to any processor the breakout board version does not have microSD holder. TECHNICAL DETAILS 2.8" diagonal LCD TFT display 240x320 resolution, 18-bit (262,000) color ILI9325 (datasheet) or ILI9328 (datasheet) or HX8347 (datasheet) controller with built in video RAM buffer 8 bit digital interface, plus 4 control lines Uses digital pins 5-13 and analog 0-3. That means you can use digital pins 2, 3 and analog 4 and 5. Pin 12 is available if not using the microSD Works with any Arduino '328 or Mega (Leonardo not supported yet) 5V compatible! Use with 3.3V or 5V logic Onboard 3.3V @ 300mA LDO regulator 4 white LED backlight. On by default but you can connect the transistor to a digital pin for backlight control 4-wire resistive touchscreen These sell for $59.00 elsewhere ours is shipped free!! in the USA

Condition:	New other (see details): A new, unused item with absolutely no signs of wear. The item may be missing the original packaging, or in the original packaging but not sealed. The item may be a factory second or a new, unused item with defects. See the seller’s listing for full details and description of any imperfections. ...	Brand	Adafruit
MPN	376