Allen-bradley Dataliner Dl50 Led Message Bulletin Display Sign 95-120v No Cord

US $450

  • Cumming, Georgia, United States
  • Nov 6th
AB ALLEN BRADLEY DL50 BULLETIN 2706-F11J DATALINER Rev C LED Display  - Comes from a working environment.  No Power cord, has not been tested.  Sold as is!  40" x 9". 2706-F11J Manufactured by ALLEN BRADLEY OPERATOR INTERFACE DATALINER 2LINE 40CH RED COLORED  The DL50 displays high visibility messages. Messages can be viewed from up to 240 feet (73.2 meters) away. This high visibility allows messages (fault, status, etc.) to be seen and responded to quickly. Messages on the 2706-F11J and -F21J units are displayed in red.  The DL50 can receive message data from several sources. Messages are sent to the DL50 in a simple ASCII format. A DL20 or DL40 display can act as a controller, or messages can originate from a  1771-T60 Industrial Terminal running Allen-Bradley Distributed Diagnostics and Machine Control (DDMC) software. A DL50 can also receive message data from other intelligent devices such as a computer or BASIC Modules (Catalog No. 1771-DB / Catalog No. 1746-BAS). In addition, the DL50 has: RS-485 port for multidrop communications. RS-232 port for point-to-point communications. Relay output for turning on a lamp, audible alarm, etc. Anti-glare display window. Variety of display modes such as wiping, smooth scrolling, etc. Easy DIP switch configuration. Multiple mounting options including: Flush Mount, Back-to-Back Mounting, and Chain Suspension. Enclosure rated for NEMA Type 12 & 13 (UL-listed) and designed but not UL listed for Type 4 (recommended for indoor use only). Universal power supply accepts 100240 VAC and 50-60 Hz. Firmware (in flash EPROM) can be updated using a personal computer and Firmware Update Disk (2706-NR4). Fault isolation LEDs show DL50 status and aid in troubleshooting. Diagnostic modes help isolate faults down to a serviceable component.  Reduced Brightness Mode prolongs the life of the displays electronics by reducing heat generated Chapter 2 Introduction to the DL50 22 The size and number of characters depends on the size of the DL50 display. Select the size of the characters based upon visibility requirements and message length . Table 2.A DL50 Display Color; Number and Size of Characters Catalog No.: 2706-F11J  Display Color Red Number of Characters 4.8 inch (122 mm) 1 line of 10                                      2 lines of 2  2.1 inch (53 mm) On Aug-30-16 at 11:10:10 PDT, seller added the following information:

Directions

Similar products from Panelviews & Interface Terminals

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies