Amprobe Acdc-3400 Ind Ac/dc Cat Iv True-rms Clamp Meter

US $484.60

Richmond Hill, New York, United States
Jan 29th

Open on mobile:
QR code

Amprobe ACDC-3400 IND AC/DC CAT IV True-RMS Clamp Meter The Amprobe ACD-3400 digital clamp meter is a true RMS (root mean square) sensing, auto- or manual-ranging multimeter for measuring current, voltage, capacitance, resistance, frequency, and duty cycles in electrical testing and heating, ventilation, and air conditioning (HVAC) applications. It has a clamp that measures alternating current (AC) and direct current (DC) to 1,000 amp. The meter comes with detachable test leads that measure DC voltage to 1,000 volts (V), AC voltage to 750V, capacitance to 6.6 millifarads, resistance to 66 megaohms, frequency to 1 megahertz (MHz), and duty cycles up to 95%. The clamp has two jaws that can close around a conductor up to 2" (57 mm) in diameter to measure current or frequency without touching or interrupting the circuit. The relative zero mode stores a reading in memory to use as a zero point for subsequent readings, allowing quick comparison of multiple readings. The peak + or - function records peak positive or negative values for AC current and AC voltage. The maximum or minimum reading mode displays the highest or lowest reading in a session to track a sudden increase or decrease in readings. It has a liquid crystal display (LCD) that shows readings both in digits and on a 66-segment bar graph. The LCD is backlit for visibility in low light. An audible continuity sensor confirms that the circuit conducts electricity, and a diode test detects whether a circuits diodes are working properly. The hold function keeps the reading on the display, even after the meter is disconnected. The unit automatically turns off after 30 minutes of non-use to conserve battery life, and a low-battery indicator signals when the meter's batteries need to be replaced. A finger guard on the body of the meter helps protect fingers from shock. This true RMS (root mean square) sensing meter provides accurate readings when measuring linear loads, such as standard induction motors and incandescent lights, where the current or voltage has a sinusoidal waveform, or non-linear loads, such as electronic devices or motors, where the current or voltage has a sinusoidal non-sinusoidal waveform. Two ranging modes (auto or manual) offer a range of operator control when taking readings. When turned on, the meter will be in auto-ranging mode and automatically selects select the correct operating range for the property being measured. It can be switched to manual-ranging mode, which requires that the operator choose the appropriate operating range. The meter has a 6,600-count resolution, meaning it can display up to 6,599 units (3-3/4 digits) before the operating range needs to be changed. It meets International Electrotechnical Commission (IEC) safety standard 61010 and is certified for category III installations up to 1,000V, which covers items used with enclosed building circuit installations (service panel parts, branch circuits, and fixed installations that are connected directly to a building's AC power supply), and category IV installations up to 1,000V, which covers measurements at the source of the low-voltage supply, such as electricity meters and overcurrent protection devices. The unit comes with a soft vinyl carrying case.SpecificationsMaximum alternating current (AC) input1,000 ampMaximum direct current (DC) input1,000 ampMaximum AC voltage input750 volts (V)Maximum DC voltage input1,000VMaximum capacitance detected6.6 millifaradsMaximum resistance detected66 megaohmsMaximum frequency detected1 megahertz (MHz)Duty cycle measurement range5 to 95%Power supply 9V NEDA 1604, JIS 006P, or IEC 6F22 battery (one, installed)Standards met and certificationsEuropean Normal (EN) International Electrotechnical Commission (IEC) and EN safety standard 61010-1 European Conformity (CE) Underwriters Laboratories (UL) Australia N10140Weight1.23 lb./559 gMeter dimensions11.1 x 4.3 x 2.1 inches/281 x 108 x 53 mm (H x W x D)H is height, the vertical distance from the lowest to highest point W is width, the horizontal distance from left to right D is depth, the horizontal distance from front to back.Clamp meters (also called clamp-on meters) measure electrical current without cutting through wires or touching or interrupting the electrical circuit. Available in handheld or benchtop models, clamp meters diagnose problems in electrical equipment, wiring, and power supplies. The meter's current clamp has two jaws that fit around a conductor to take measurements. All clamp meters test for current. Some come with test leads and inputs for measuring voltage, capacitance, and resistance. They display information either in analog or digital form. Factors that influence meter choice include the electrical properties to be measured, the anticipated range of results, and the desired level of protection against transient voltages determine meter choice. Safety ratings are based on the International Electrotechnical Commission's (IEC) standards for low-voltage test equipment. IEC 61010 delineates four overvoltage installation categories. In general, a meter with a category IV rating will provide more protection against transient voltages than a meter with a lower category rating.Amprobe manufactures electrical testing equipment for commercial, industrial, and home use. The company was founded in 1948 and is headquartered in Everett, WA.Whats in the Box? ACD-3400 TRMS clamp multimeter (1) Test lead set (1) 9V battery (installed) Soft vinyl carrying case Instructions Product Features: Digital clamp meter measures alternating current (AC) and direct current (DC) to 1,000 amp, DC voltage to 1,000 volts (V), AC voltage to 750V, capacitance to 6.6 millifarads, resistance to 66 megaohms, frequency to 1 megahertz (MHz), and duty cycles True RMS (root mean square) sensing meter provides accurate readings when measuring linear or non-linear loads, where the current or voltage has a sinusoidal or nonsinusoidal waveform Clamp with a 2" (57 mm) jaw opening measures current without touching or interrupting the circuit Relative zero mode stores a reading in memory to use as a zero point for subsequent readings, allowing quick comparison of multiple readings Meets International Electrotechnical Commission (IEC) safety standard 61010 and is certified for category III installations up to 1,000V and category IV installations up to 600V Dimensions (in): 3.30 X 12.30 X 5.50 ____________________________________________________________ Important Information: We offer discounted rates for bulk purchases, please inquire. We combine shipping, please note that certain items cannot be combined. In case you don&rsquot see the shipping rate displayed, please feel free to contact us for a shipping quote. _________________________________________________________________ International Shipping: Ø if you need a super fast international shipping please contact us Ø We do combine shipping, the more you buy the lower the shipping cost. Ø International shipping may be subject to a longer handling time. Ø Estimated time in transit is still just an estimate, in some cases items are subject to an extended time in transit due to custom delays, extended inspections in your country or lack of efficiency of the postal service. Ø USPS Standard mail or Priority mail are not guaranteed to be trackable, the service which is guaranteed to be trackable is USPS EXPRESS mail. Ø Most items are shipped with USPS. However, if you prefer a different shipping method, please notify us prior to purchase. Ø We cannot be responsible for time in transit, custom fees or for custom delays. Ø All international items are insured. Thank you for Looking! You may be interested in our other listings on eBay.

Condition:	New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...	Brand	Amprobe
Size Type	Regular
UPC	0095969492683
Model	ACDC-3400 IND