ATMega328p board w/ NRF24l01+ breakout socket in Arduino PRO format +DHT22 port, US $87 – Picture 0

ATMega328p board w/ NRF24l01+ breakout socket in Arduino PRO format +DHT22 port, US $87 – Picture 1

ATMega328p board w/ NRF24l01+ breakout socket in Arduino PRO format +DHT22 port, US $87 – Picture 2

ATMega328p board w/ NRF24l01+ breakout socket in Arduino PRO format +DHT22 port, US $87 – Picture 3

ATMega328p board w/ NRF24l01+ breakout socket in Arduino PRO format +DHT22 port, US $87 – Picture 4

Atmega328p Board W/ Nrf24l01+ Breakout Socket In Arduino Pro Format +dht22 Port

US $87

Ljubljana, Slovenia
Feb 23rd

Open on mobile:
QR code

ATMega328p board with NRF24l01+ breakout in Arduino PRO format +I2C socket +DHT22 socket +1.25A Mosfet +ESP8266 ESP-05 socket Fully Arduino compatible with Arduino PRO Mini 3.3V @ 8MHz bootlader NRF24l01+ radio breakout port with CE and CSN pins connected to digital pins 7 and 8 ( you use RF24 radio(7, 8); in Arduino code). There is a 4.7uF capacitor connected across Vin and GND of the port Bigger LDO voltage regulator The board comes with an AMS1117 3.3V as a standard. It can be equipped with a MICROCHIP TC2117-3.3VDBTR upon request. Two breakout ports with SDA and SCL lines and 10k pull-up resistors for external I2C components, connected to A4 and A5 DHT11/22 port with 5.1k pull-up resistor and connection to D5 ESP8266 ESP-05 socket breakout pins are for power supply and GND connections. Top one is power, bottom one is GND. RX and TX pins are not connected to ATMega328p, not to interfere with programming. 1.25 amp, 30V, N-channel MOSFET for regulating external components such as solenoids. The gate is connected to D4 and the output is protected with a Schottky diode. Low power (2mA) LEDs that are connected via solder jumpers. Jumpers need to be soldered in. There are few such boards available and none with this kind of versatility. This board is perfect for low-power applications. Identical - small - footprint as Arduino PRO. Only better. It is intended for sensor applications and can be used as an universal board for sensor node networks. Dimensions are 2 inch x 2.1 inch. The board is 1mm narrower than Arduino PRO, to fit into 2inch slot of an enclosure. Documentation: http://i.imgur.com/NkZFNhR.jpg http://i.imgur.com/IXeTH6I.png

Condition:

New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...

Brand

Arduino