Belt Grinder 2x72 Wheel Set For Knife Grinders With Steel D-plate 5/8"

US $14000

guangzhou guangdong, China
Jun 4th

Open on mobile:
QR code

This listing: 1. A set of: Two, 2" diameter precision glass filled nylon idler wheels with sealed bearings, 2-1/4" WIDE (CHEAP WHEELS ARE 2" WIDE). One, 3" diameter precision glass filled nylon tracking wheel with sealed bearings. The tracking wheel is 2-1/4" wide, 3" in diameter & CROWNED (no sharp v) to ensure accurate belt tracking. One, 5" diameter precision glass filled nylon drive wheel with aluminum core. The drive wheel is 5" in diameter for high surface feet per minute belt speed & crowned to ensure accurate belt tracking, slightly dimpled to add extra grip . The face of the drive wheel is 2-1/4". The set screw(included) is 1/4-20 . Please note that the bore of this drive wheel is 5/8", see our other listings if you require a drive wheel with 3/4" or 7/8" bore. For DIY style grinders like GIB, EERF, NO WELD etc. Also work well on any professionally manufactured 2x72" belt grinder. Made with the exact same injection molding technology & material as used on modern automotive engine serpentine belt idler wheels for extreme durability & longevity under very harsh conditions. The wheels are 2-1/4" face width to comfortably accept any commercial 2" wide grinding belt. Bore of the bearings is 1/2" so you can use any 1/2" diameter bolt as an axle. The bearings are easily replaceable when worn. We use these wheels on the top quality grinders & flat platens that we manufacture & our design has been thoroughly tested to withstand even the harshest knifemaking environments! 2. D-shaped backing plate for flat platten assembly, this one with even deeper reach for slack belt grinding. This plate is precision cnc cut from 3/8" hot rolled steel. Wheel mounting holes are 1/2-13 precision tapped to ensure that axles are perpendicular to the plate. The centre mounting hole is 1/2" diameter, the slots for a flat platten mounting bracket are 1/4" wide & 6" apart, the u-shaped adjusting slot accepts a 3/8" bolt or stud. The axle holes are 10.5" center to center apart; if you mount two 2" diameter wheels on this backing plate you can easily mount an 8" long by 2-1/2" wide flat platten between the wheels for a large grinding surface. The rectangular spacer plate is 1/8" thick, this effectively makes this plate 1/2" thick through the pivot point & therefore interchangeable with any 1/2" thick d-plate. We include 2 grade 8 bolts, 3,5" long, 1/2-13 thread, with 4 nylon spacers, 2 1/2" washers & 2 half-nyloc nuts. Please also have a look at our other listings, visit our Ebay store & search OregonBladeMaker on Youtube for some other fun stuff.