Containment Technologies Group Mic Single Chemo Glove Box/isolator A1000r

US $2000

Phoenix, Arizona, United States
May 27th

Open on mobile:
QR code

Containment Technologies Group MIC Single Chemo Glove Box/Isolator A1000R Comes with what you see in the pictures. If you don't see it, you probably wont get it. Specifications are from Containment Technologies and may vary slightly due to upgrades, options, or revisions this unit may or may not have. This unit came from the Department of Corrections in Washington. It is in EXCELLENT condition. It looks like they may have never used it. There are 2 sharps containers that come with it that are not pictured. The start up kit looks complete or very close to it but I am not sure what normally comes in it so I cannot guarantee anything. The unit is guaranteed to work. The Unit's Serial Number Tag Reads: Model Number: MIC SINGLE Serial Number: 0613-EMPA-870 Power Requirements: 120 V, Single Phase, 60 Hz Additional Chamber Information: Air Lock Opening Dimensions: 11.625" W x 10.75" H Approx. Air Lock Dimensions: 15" D x 15" W x 10.75" H Approx. Chamber Dimensions: 27" H x 40" W x 24.75 D on the bottom, 20" D on the top. Approx. Configuration from the Factory: MIC Single Chamber with Right Air-Lock - Positive or Negative Pressure Description: Consists of one independent gas tight chamber Can operate at either negative or positive pressure Can operate without a negative pressure clean room and without any venting 56" L x 46" D x 78" H (single airlock) Adjustable height Body - 316L stainless steel Viewing portion - chemical- and shatter-resistant plastic Oval glove ports are standard Lighting - recessed and sealed from work chamber Filtration - HEPA filter 99.99% effective with particles of greater than .5 micron. Air flow enters and exits chamber through HEPA filters (ISO Class 5) Rolls through standard pedestrian doorway Self-contained, locking casters Smooth surfaces facility cleaning ISO Class 5 conditions maintained by controlled entrance and exit of product and personnel. Product enters through air lock. Personnel work through glove ports without entering the interior. Electrical Requirements: MIC Single requires a standard 120 V outlet single receptacle. The MIC has a factional horsepower centrifugal blower and light wired into a single cord with standard three-prong plug. The power requirement is less than 1.5 amps. The lighting source is mounted exterior to the interior of the workstation. The unit does not require a dedicated circuit. There is no heat load or heat transfer between the unit and the ambient room. Filtration and Air Handling Systems Both entering and discharged air from the chamber shall be HEPA filtered. The quality of filtration provided by the HEPA filters shall be certified to be 99.99% efficient for particles of .3 micron or larger. The internal environment shall meet ISO class 5 conditions. Internal filter faces shall be covered with a membrane allowing the surface to be cleaned. The air handling system does not require venting. If ventted the vent is a four inch discharge which typically is attached from the outside vent to the MIC with flex. If vented the vent should be a four (4) inch round duct extending six inches below the ceiling. The duct should deliver 135 cfm at the discharge room. Location should be at the center of the discharge filter box which is located on the right side of the MIC (facing the unit) positioning is not critical as the flex connection will compensation for minor location variance. The system shall be capable of operating under either positive or negative pressure. The pressure control should be changeable after installation. For More Pictures Please Click the Following: Picture 2 - Back View Picture 3 - Right Side View Picture 4 - Left Side View Picture 5 - Pressure Display Picture 6 - Light & Blower Buttons Picture 7 - Start Up Kit Picture 8 - Serial Number Tag $150.00 minimum for packaging, handling, and order processing. Shipping to be determined by destination. Prior to shipment I need to know the following information: (1) Are you the end-user of this item? (2) If you are not the ultimate end-user of the item, please state the ultimate end user's name. (3) What is the ultimate country destination? If you have any questions please call Michael at 1-866-MHZ-ELEC (1-866-649-3532) Toll Free. Also, please click here to view or other auctions! 08/19/15 Powered by eBay Turbo Lister The free listing tool. List your items fast and easy and manage your active items.