Denon Sc-7000z Desoldering Tool

US $370.00

  • Papa, Veszprem, Hungary
  • Jan 31st
Features Direct connection between the diaphragm pump and the tip can provide high vacuum efficiency which can accommodate for the 8-12 layered PCB. The combination of a 100W ceramic heater with sensor feedback temperature control circuit and high vacuum capacity can provide best work efficiency with no failure. Protection against ESD is secured. Quite compact, light-weight unit portable and ready to use at any location. Low noise and low vibration. The removal of SMD components can be easily done by a flick of the selector lever and by replacing the tip with the hot blow nozzle. Applications Removing the solder of DIP by the suction tip Melting the solder of QFP/SOP by the hot blow for removal Melting the solder of PLCC by the hot blow for removal Melting the solder of other SNDsby the hot blow for removal Time Required to Reach the Maximum Vacuum Specifications Voltage AC100V, 120V, 230V, 50/60HZ Power Consumption 120W Pump Diaphragm type Motor output 12W Vacuum attained -86kpa Time required to reach maximum vacuum 0.1 seconds Air flow rate (OPEN) 15 liter/minute (Open) Heater 100W (Ceramic) Control System Feed back zero cross over type Temperature Range 350 - 500°C Insulation resistance More than 100M? Max.Temperature of hot blow 400°C Weight 420g
Condition Used :
An item that has been used previously. The item may have some signs of cosmetic wear, but is fully operational and functions as intended. This item may be a floor model or store return that has been used. See the seller’s listing for full details and description of any imperfections.
Seller Notes Lightly used, in perfect condition.

Directions

Similar products from Soldering Irons & Stations

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies