ECON-AIR E-76 1800 CFM NON-RECIRCULATING DIRECT GAS FIRED INDUSTRIAL AIR HEATER, US $3,598.99 – Picture 0

ECON-AIR E-76 1800 CFM NON-RECIRCULATING DIRECT GAS FIRED INDUSTRIAL AIR HEATER, US $3,598.99 – Picture 1

ECON-AIR E-76 1800 CFM NON-RECIRCULATING DIRECT GAS FIRED INDUSTRIAL AIR HEATER, US $3,598.99 – Picture 2

ECON-AIR E-76 1800 CFM NON-RECIRCULATING DIRECT GAS FIRED INDUSTRIAL AIR HEATER, US $3,598.99 – Picture 3

Econ-air E-76 1800 Cfm Non-recirculating Direct Gas Fired Industrial Air Heater

US $3,598.99

Pontiac, Michigan, United States
Jan 29th

Open on mobile:
QR code

ECON AIR DIRECT GAS FIRED INDUSTRIAL AIR HEATER NON-RECIRCULATING * DELIVERS TEMPERED MAKE UP AIR ROOF TOP UNIT with CONTROL BOX ****INDOOR OR OUTDOOR USE**** Model No: AA-4-ETL ~ Serial No: 13626-4 1,800 CFM Air Volume 230 Volts - 60 Hertz - 1 Phase - 10.2 Full Load Amps - 1.5 HP PRODUCT OVERVIEW: The Direct Gas Fired Make-Up Air is designed to deliver tempered make-up air for installations requiring frequent air changes. This unit is designed for natural gas applications, and for indoor or outdoor installation in commercial occupancies. Direct Gas-Fired Heater, for use in tempering make-up air. This unit is certified to the ANSI Z83.4-Second Edition and CSA 3.7-2006 combined safety standards. One size is available with a max BTU rate of 241,290 and 1,800 CFM. A unique feature is the self-adjusting burner profile plates allowing 2-speed and variable-air-volume applications. The plates ensure proper air velocity and pressure drop across the burner for clean combustion. Spring-loaded profile plates react to the momentum of the fresh air stream, therefore, no motors or actuators are needed to drive them, nor do they need to be manually set to a specific position. Unit consists of a galvanized enclosure with an elevated gas burner which burns directly in the air stream. The burner consists of non-clogging, stainless steel combustion baffles attached to a cast iron gas supply section. The burner is capable of nearly 100% thermal efficiency with a maximum turndown ratio of 15 to 1. The products of combustion mix with the make-up air which is introduced into the heater intake directly from outside the building. The burner module has a standard horizontal inlet and discharge duct connection and is located upstream of the blower. The heater has a standard horizontal inlet designed to accommodate an outside air inlet hood with standard 2” filter and screen. To satisfy a variety of installation requirements, packages are available in a number of configurations which include additions of filtered intake with easy access door and a trunkline that is used to move the air intake away from the grease laden exhaust air. Screened intakes are used to stop debris from being pulled in to the heater. The screened intake attaches directly to the filtered intake or the trunkline. Combination packages that include both exhaust and supply fans mounted on a single roof curb are also available, please contact your sales representative for more information. Features & Benefits • G90 galvanized construction • Easy access doors • Pre-wired, pre-piped controls • Horizontal or down discharge • Adjustable drive sheaves • Fully insulated casing • Stainless steel burner with aluminum casting • 120 volt control transformer with single point electrical connection • Redundant gas valves • Intermittent spark pilot with timed safety lockout • Electronic flame modulation • High temperature limit switch • Airflow proving switch • Economizer inlet thermostat • Motor starter • Disconnect switch • Burner observation port ITEM IN PICTURES IS THE EXACT UNIT YOU WILL BE PURCHASING! THIS ITEM WAS IN PERFECT WORKING ORDER WHEN REMOVED FROM RESTAURANT. THIS ITEM IS VERY CLEAN AND HAS NO APPARENT DAMAGE. THIS UNIT WAS REMOVED IN OCTOBER 2014 AND PLACED IN OUR WAREHOUSE FOR STORAGE. THIS UNIT IS USED AND IS BEING SOLD AS IS WITH NO WARRANTY. NO REFUNDS, RETURNS, OR EXCHANGES WILL BE GRANTED. PLEASE CALL IF YOU HAVE ANY QUESTIONS OR CONCERNS! 248.819.1999 LOCATED IN PONTIAC, MI 48340 This unit was removed from a working environment. All Used Equipment is Sold As Is with No Warranty. No Refunds or Exchanges Permitted

Condition	Used : An item that has been used previously. The item may have some signs of cosmetic wear, but is fully operational and functions as intended. This item may be a floor model or store return that has been used. See the seller’s listing for full details and description of any imperfections.
Seller Notes	“EXCELLENT WORKING CONDITION! VERY CLEAN!”