Electric Solder Sucker Soldering Irons Desoldering Pump Removal Tools 220V, US $8.99 – Picture 0

Electric Solder Sucker Soldering Irons Desoldering Pump Removal Tools 220V, US $8.99 – Picture 1

Electric Solder Sucker Soldering Irons Desoldering Pump Removal Tools 220V, US $8.99 – Picture 2

Electric Solder Sucker Soldering Irons Desoldering Pump Removal Tools 220V, US $8.99 – Picture 3

Electric Solder Sucker Soldering Irons Desoldering Pump Removal Tools 220V, US $8.99 – Picture 4

Electric Solder Sucker Soldering Irons Desoldering Pump Removal Tools 220V, US $8.99 – Picture 5

Electric Solder Sucker Soldering Irons Desoldering Pump Removal Tools 220V, US $8.99 – Picture 6

Electric Solder Sucker Soldering Irons Desoldering Pump Removal Tools 220v

US $8.99

HONG KONG, none, Hong Kong
Jan 31st

Open on mobile:
QR code

Noble brand XS-842A electric dual-use suction tin with good looks, novel structure, easy to use desoldering clean and so on, to use it can easily want to change the components from the circuit board to take down without damage to components and circuit board. More prominent for the replacement of the advantages of integrated circuits, multi-pin switch. Desoldering can be used for the general use of electric iron, an essential tool for national defense, scientific research, communications, aerospace, computer, radio, television, electronic professional maintenance staff and the majority of radio enthusiasts. [Use:] Desoldering use voltage of 220V-50Hz, power 30W Power, warm-up 3-5 minutes The piston under the push of the handle stuck, Desoldering iron nozzle front end alignment Give the next component of the solder until the solder melts, pressing the control button, the solder is sucked into the pump Suction tin with two different diameter nozzle can be selected according to the thickness of the component leads Welding with the use of electric iron operating Forced under the direction of the arrow, the upper end of the demolition pump, pump pressure, poor at the same time the pump handle is pulled, the pump can be isolated, remove the nozzle, the nozzle counterclockwise rotating can be nozzle Remove the [Note:] First, check the voltage are consistent with high or low voltage is not conducive to use Use before you want to nozzle and tighten the pump part, to prevent the leak, otherwise the impact of the effect of tin absorption Often clear the solder impurities into the nozzle and pump, and a little oil to live Saiga 4, each time after use, to promote the Pistons 3-4 times to remove residual solder within the straw, so that the nozzle and straw smooth for use in the next Desoldering is powered strictly prohibited installation and removal of parts of its electric part. First use of the six, Desoldering reheat due to heating element may be a slight smoke, which is a normal phenomenon will disappear naturally after ten minutes Seven during use must be equipped with the natural radiation structure of the iron seat and should be placed in the iron base VIII. If the power cord is damaged, in order to avoid danger, to be replaced by the manufacturer, or the maintenance department or similarly qualified persons , The products are ground, should be equipped with the socket with contacts, please pay attention to use, for safety's sake. Package: 1 Qty. (Shown as picture)