Elo Touchsystems Ctr-270100-it-rsu-00r **new**

US $880

  • Fort Lauderdale, Florida, United States
  • Jan 29th
Supply Voltage and Current +5 VDC, nominal (+4.75 to +5.25 VDC) Operating current 75mA, maximum at +5 VDC. Typical power dissipation is 300mW at 5V. Inrush current of up to 600mA for 50mS following power on Supply must be capable of sourcing 200 mA, minimum. Total noise and ripple requirement must be less than 100 mV (p-p) for frequencies below 1 MHz, and less than 50 mV (p-p) for frequencies above 1 MHz. Serial Interface EIA 232E (Serial RS-232), DCE configuration. 8 Data Bits, 1 Stop Bit, No Parity, Full Duplex Hardware handshaking: RTS/CTS DSR is pulled HIGH (>+3V) by the 2701RSU when connected and powered. DTR can be asserted by the host to interrupt the flow of data from the controller. Note that if the application does not monitor CTS, then an interval of approximately 5 seconds should be inserted between the issuance of a reset command and any other command. Baud Rate 9600 (default) and 19200 USB Interface The CTR-270100-IT-RSU-00R controller is an interrupt-type, full-speed USB device. Operating Modes Full IntelliTouch SmartSet protocol Customer specific protocol Initial/ Stream/ Untouch Modes Touch Resolution 4096x4096, size independent Conversion Time Approximately 10 ms per coordinate set Reliability MTBF greater than 1,543,000 hours per MIL-HDBK-217-F2 using the parts stress calculation method for ground benign environment with an ambient temperature of 25°C

Directions

Similar products from Electrical breadboards

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies