Emco F1 & Pcmill 50, 55 Cnc Mill ,iso-30, Er-25 Collet Chuck Er25 1pc.

US $390

  • Warren, Michigan, United States
  • Jun 17th
You will get 1PC. ISO-30, ER-25 Collet Chuck . As you may notice that most of tool holders for Emco F1,PCMill 59 and 55 . This holder is better then original holder . Emco holders are made as one pice ,pull stud is not replaceable,holders not hardened and not grounded,also not balanced. When used a lot ,thy will loos retention in the spindle. This holder is hardened and grounded,also balanced at 15000 RPM, and have replaceable hardened  pull stud. This holder made same as industrial tool holders. You may ask yourself ,Why I need balance my tool holder when my machine do not run that high RPM. When toll holder is not proper balance ,cousin vibration of the spindle. It is bad on the bearing and finish cut is not good. Emco holder  not BT30,thy are  ISO30. 

Directions

Similar products from Motors with Power of 5.1 HP - 10 HP

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies