F-scan2 Frequency Synthesizer

US $2164

  • Malden, Massachusetts, United States
  • Jun 20th
F-Scan2 Main Features  Touch Screen -  backlit monochrome screen - all settings and commands are entered on the touch screen Single Output port on the right side of device can be programmed and provides Sine, Square and Square / 5volt signals Sine wave signals are delivered DC-Offset with a constant amplitude of 10vpp Square wave signal output at FULL WAVE or DC Offset - selectable with a switch. Amplitude adjustable from 0 vpp - 27 vpp or 13.5 vpp Power port on left side of device provides amplified square wave signals synchronized with those available on the Output Port for use with Light or Magnetic Coil adapters, etc.  The output range is from 0.1 Hz. to 1,000,000 Hz. with a constant amplitude of 14 vpp Two frequency tables are permanently stored in memory and items can be selected by index number or with a touch on an alpha-sorted name table and transferred to the operating memory Frequency values between 0.1 Hz and 3,000,000 Hz can be entered for square wave signals and between 0.1 Hz and 15,000,000 Hz for sine wave Permanent memory - has built-in list of 235 pathogens and their frequencies as identified by Dr. Hulda Clark and a listing of 350 Rife frequencies. Integrated adjustable common and multiple individual Timer SWEEP Mode - for wide-band application of frequencies WOBBLE Mode - when enabled, the signal will swing around the target frequency in a band selectable in 27 steps between 10 Hz and 9,000 Hz Sweep - to - Next - mode enables frequency sweeps between any two values of a frequency sequence User accessible memory - provides capacity to store 50 data blocks permanently (until overwritten).  Each data block can consist of up to 50 frequencies (with One decimal, if required), their assigned Signal Form and the Sweep-to-Next choices (if applicable) AND a complete data set of a DIRP run (maximum 1,000 analysis steps). Some user designated settings remain stored after unit is shut off, until the user changes them again. The internal software of the device can be updated via data transmission through the RS232 communication interface without replacing hardware.

Directions

Similar products from Function Generator Modules

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies