Ft232bm/bl Seagate Barracuda 7200.11 Firmware Fix Tool, Complete, Usb Powered

GBP 12.50

EU, Bulgaria
Jan 29th

Open on mobile:
QR code

Seagate Barracuda Fix Barracuda Seagate Fix tool This device will help you to fix LBA or BSY error on Seagate Barracuda. There are two common errors on Seagate 7200.11 HDDs (caused by bugs on firmware): - 0 LBA error: it happens when your BIOS can recognize your HDD at POST moment, but as an 0MB drive. - BSY error: it happens when your HDD enter on a halt state, or BuSY state.In this condition, your HDD will not be recognized by BIOS at POST moment. Loopback Test Software KMTronic_Loopback_Tester.zip Connect the cables just like on the picture below: TX of the module <-> RX of the Hard Drive RX of the module <-> TX of the Hard Drive Connect the module to the computer. If drivers are needed download at : http://www.ftdichip.com/Drivers/VCP.htm Now run the HyperTerminal or other software and configure like the pictures below. ( --- HyperTerminal for Windows 7 --- ) Choose the correct COM port where the FTDI module is connected (in this case COM3) Configure with these parameters: OK, now you are ready to power up the HardDisk. Connect the power cable and wait. When power is applied you have to see this: After you have connected the power to the HardDisk, press CTRL+Z in your HyperTerminal session. You should now see a prompt like this: More information about how to make it work: http://www.msfn.org/board/topic/128807-the-solution-for-seagate-720011-hdds/

Condition:	New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...	Cable Length	1m
USB Specification	USB 2.0
Type	Adapter/Converter
Connector A	USB Type B Male