GEORG FISCHER SIGNET 9900 Direct Conductivity/Resistivity Module 3-9900.394, US $149.95 – Picture 0

GEORG FISCHER SIGNET 9900 Direct Conductivity/Resistivity Module 3-9900.394, US $149.95 – Picture 1

Georg Fischer Signet 9900 Direct Conductivity/resistivity Module 3-9900.394

US $149.95

Carlsbad, California, United States
Feb 20th

Open on mobile:
QR code

9900 Direct Conductivity/Resistivity Module The Signet 9900 Direct Conductivity/Resistivity (Cond/Res) Module interfaces Signet 2819-2823 and 2839-2842 Conductivity electrodes directly to the 9900. (Conductivity/Resistivity and Salinity measurements may also be performed via the 2850 Sensor Electronics connected through the 9900 Digital (S3L) inputs.) Advantages: Provides filtering and conditioning Sensor cable length can be extended to 30 m (100 ft) (except 2819-2839: 4.6 m (15 ft) max for >10 M, no splices) Signet 9900 Direct Conductivity/Resistivity Module Instruction Sheet 3-9900.092 Rev. A 4/11 English ? Terminals accept 16 to 28 AWG wire. ? Sensor cable length can be extended to 30 m (100 ft) (except 2819 and 2839, limited to 4.6 m (15 ft). ? Strip 10 to 12 mm (0.4 to 0.5 in.) of insulation from wire tips and tin bare ends to eliminate fraying. ? Insert wire tip or ferrule completely into the terminal and secure with the screw. ? Do not allow any AC leads that may be connected to the internal relays to come in contact with low voltage wiring. *3-9900.092* Field Mount and Panel Mount are identical. 2819-2823 2839-2842 If the 9900 Base Unit will be mounted in a panel, plug-in modules may be installed either before or after the base unit is mounted. If the 9900 Base Unit will be mounted using the accessory wall mount bracket, install plug-in modules fi rst. The Conductivity/Resistivity module plugs in and attaches with a screw. 1. It may be helpful to use a standard screwdriver to gently pry removable terminals away from the receptacle on the plug-in modules. Reverse this step to reinstall the panel after the plug-in modules are installed. 2. Remove terminals from the receptacle of each plug-in module prior to installation. To interface a stand-alone conductivity sensor (2819-2823 or 2839-2842) to the 9900, the 3-9900.394 Direct Conductivity Module must be used. CAUTION: Exercise care when installing module. Do not bend connecting pins. Align pins and connectors then push module fi rmly into place, then attach with screw. Avoid Electrostatic Discharge (ESD): ? Minimize handling of module to reduce the possibility of damage due to ESD. ? Handle module by the edges. Never touch any exposed circuitry or contacts. ? Wear an anti-static wristband or stand on an anti-static mat, or keep one hand touching a properly grounded pipe or other properly grounded piece of metal when handling module.

Condition:	New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...	Brand	Georg Fischer Signet
MPN	3-9900.394
Model	9900 Direct Conductivity/Resistivity Module
Country/Region of Manufacture	United States