GPR Ground Penetrating Radar Antenna Geophysical Survey Corp 5106, US $3,250.00 – Picture 0

GPR Ground Penetrating Radar Antenna Geophysical Survey Corp 5106, US $3,250.00 – Picture 1

GPR Ground Penetrating Radar Antenna Geophysical Survey Corp 5106, US $3,250.00 – Picture 2

GPR Ground Penetrating Radar Antenna Geophysical Survey Corp 5106, US $3,250.00 – Picture 3

GPR Ground Penetrating Radar Antenna Geophysical Survey Corp 5106, US $3,250.00 – Picture 4

GPR Ground Penetrating Radar Antenna Geophysical Survey Corp 5106, US $3,250.00 – Picture 5

GPR Ground Penetrating Radar Antenna Geophysical Survey Corp 5106, US $3,250.00 – Picture 6

GPR Ground Penetrating Radar Antenna Geophysical Survey Corp 5106, US $3,250.00 – Picture 7

GPR Ground Penetrating Radar Antenna Geophysical Survey Corp 5106, US $3,250.00 – Picture 8

GPR Ground Penetrating Radar Antenna Geophysical Survey Corp 5106, US $3,250.00 – Picture 9

GPR Ground Penetrating Radar Antenna Geophysical Survey Corp 5106, US $3,250.00 – Picture 10

Gpr Ground Penetrating Radar Antenna Geophysical Survey Corp 5106

US $3,250.00

Bella Vista, Arkansas, United States
Jun 9th

Open on mobile:
QR code

The Model 5106 antenna has greatly improved resolution performance over previous GSSI midfrequency antennas, such as the Model 3105 (300 MHz). The Model 5106 can be used in continuous, survey wheel or static stacking modes. System Setup - Standard Settings Shallow Profiling: Range/Depth is approximately 7m assuming a dielectric constant of 9. Setup Mode: Manual System Run Mode: Survey Wheel (recommended) or Continuous Range:150 ns Number of Gain Points: 5 Vertical Low Pass Filter: 400 MHz Vertical High Pass Filter: 30 MHz Samples per Scan: 512 Bits per Sample: 16 Scans per Second: Set to the maximum scan rate allowed by the SIR System used. Deep Profiling: Range/Depth is approximately 15m assuming a dielectric Setup Mode: Manual System Run Mode: Survey Wheel (recommended) or Continuous Range:300 ns Number of Gain Points: 5 Vertical Low Pass Filter: 400 MHz Vertical High Pass Filter: 30 MHz Samples per Scan: 1024 Bits per Sample: 16 Scans per Second: Set to the maximum scan rate allowed by the SIR System used. Signal Position Place the antenna on the ground and use the Automatic Signal Position selection. The system will servo and place the direct coupling pulse at the top of the time range window. To test that you have the correct position, raise the antenna off the ground and you will observe on your system that the antenna transmit pulse will separate from the reflection from the ground. The higher that you raise the antenna, the further apart will be the two pulses. To assure that the direct coupling pulse (time zero) is recorded the user should place the signal Position servo in the manual mode. The signal should then be moved down in the time range window until the entire surface pulse is visible and there is some ‘dead time’ or flat trace visible above the direct coupling pulse in the time range wind ..Has not been tested and is sold as is...Excellent condition..Shipping is to the lower 48 by the most cost effective carrier Between UPS, FedEx or the Postal ServicePayment of $250 24 hours after purchasing and the remainder to be paid through Cashiers check, travelers check. money order or bank transfer..Is listed for sale on clist in Tulsa..Very Clean unit! Will ship to the USA only!! Shipping price is to the lower 48

“Excellent Condition. See payment conditions”

Brand	GSSI
Model	5106