Helical Head For Metabo Mptdh330 Dh330 Dh 330 Thicknesser 40 Carbide Inserts

US $472.00

Waterloo, Ontario, Canada
May 31st

Open on mobile:
QR code

Woodworkers are now retrofitting spiral cutterheads to their old planers, jointers for the following advantages. * Smoother Finish with no tear-out. Each knife sits at a slight angle and produces shear-cut . Spiral cutterhead planes board in a staggered way which is much better than a single straight cut. The combined shear and staggered cut eliminates tear-out and leaves a glossy surface finish on even highly figured hardwood. * Noise is dramatically reduced as spiral cutterhead allows a few knives to cut in a staggered way. * More than 10 times the life use of high-speed steel. The 15x15x2.5mm inserts are made of sintered tungsten carbide which is much harder than high-speed steel. Each insert has four edges. * Easy to change. The knives are precision ground to a tolerance of +/-0.0004" or +/-0.01mm and are interchangeable. Loosen the screw, rotate 90° for a new edge, tighten the insert in minutes. * Dust extraction is easier. Spiral cutterhead produces thinner and shorter chips. * Low cost to use. Spiral cutterheads produce a smoother finish, reduce or eliminate sanding work, don't require sharpening, your product will pay for itself in a very short time. Technical Material of Cutterblock Alloy Steel No. of Spirals 4 No. of Carbide Inserts 40pcs Carbide Insert Size 15x15x2.5mm R150 30° Screw Size T25 10#-32TPI Standard Kit No. of Additional Knives 5 No. of Additional Screws 5 No. of Wrenches 1 No. of Bearings 2

Condition:	New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...	MPN	S01294
Brand	Sheartak
Max Planing Width	330mm
UPC	Does not apply