Hytrol 033.09002 (automation Controls Group – Smc?) Flat Dc Motor Controller

US $100.00

  • Cedar, Minnesota, United States
  • Jan 29th
We got these from the spare parts crib at a very technically elaborate and well maintained candle factory. This is revision V1.4    Maximum power out is 125 Watts at 28 VDC and 10 – 270 RPM. It is very simple to use with the Automation controls group UniDrive Model 110165 brushless DC “Flat” Motor. Just plug the motor onto the 8 pin connector, apply 24 VDC to the power pins, and provide a 24 volt run signal to the round micro connector outside 2 pins. NOTE: The 2 pole power input terminal strip plug is NOT INCLUDED. Speed is set by the small potentiometer. One of the dip switches reverses the motor; the other 3 don’t seem to have any effect. There are 2 “smart” inputs and 2 “smart” outputs that also don’t appear to be used for anything as they were not wired. THE MOTOR IS NOT INCLUDED!     If you want a good little 100 watt, 10 – 270 RPM motor to use with it,  search “Unidrive” in our store.   NOTE:  A pin was broken out of the circular connector on this unit so I took it off and use the 2 wires to start the motor. This would NOT be a good SPARE. BUT, if you don’t plan to use it with a Hytrol Zone controller, you can avoid buying a $10 female to plug it in.  So it actually saves $35 over an undamaged unit. 0.5 Lbs. - Shipping USPS. QZ1411 02A
Condition Used :
An item that has been used previously. The item may have some signs of cosmetic wear, but is fully operational and functions as intended. This item may be a floor model or store return that has been used. See the seller’s listing for full details and description of any imperfections.
Seller Notes No micro connector

Directions

Similar products from DC Motor Speed Control Systems

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies